tested ms confirmed - "stop lamp" fuse pulled = stand still burnouts allowed

xdeslitx · 08-18-2010, 08:55 AM

Quote:

Originally Posted by Z eliminator

Its a pain to remove and a bigger pain to reinstall, I use needle nose plyers on the fuse,
And the burn outs are good 7000 in second gear gets the tires hot. You can see my burn outs in the " drag section , Under Z eliminator drag videos,
I have drag radials on the car.

Z

This is the fuse box right? and it's the stop lamp fuse that needs to be taken out? I just don't want to be mistaken.
How is it a pain to remove and reinstall? When I look at the fuse box by the driver side, it seemed pretty straightforward. I quickly found the stop lamp fuse. Shouldn't the little plastic "fuse clip" be enough to take it out?

Everything goes back to normal though, when you reinsert the fuse? Nothing out of the ordinary happens?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY: Rear Fog-Lamp "Z" light	Caravanshaka	DIY Section (Do-It-Yourself)	20	09-13-2014 05:02 PM
Do It Yourself Fog Lamp (EASY)	lastblueprint	DIY Section (Do-It-Yourself)	84	06-05-2014 02:08 PM
"Warning" Carbon Fiber Z emblems "DO NOT FIT"	NXTAZEE	Exterior & Interior	2	12-20-2009 03:49 AM