Who's making the move to STU?

///maestro

I'd say the right suspension setup would make more of a difference than the VLSD. From what I've read, the VLSD isn't "terrible" until it starts going, then eventually only 1 wheels spins at all times.



I Just ran my car for the first time at Gingerman raceway. WOW! Love the way I have the car configured so far. Word of wisdom, don't use EBC Red Stuff for track use!! I made a huge mistake and they started glazing (melting) causing my car to shake. Car handled very well and after months of building, adjusting, tweaking...I think the car performed very well. The whiteline swaybar I added paired with my coilovers worked very well. I do need to stiffen my front coilovers a bit as I was rubbing in hard cornering. I think I will get an OS Giken diff next season (over winter) along with some racing bucket seats and a roll cage.

As for my pad issue, I spoke to a few people, I'll be making the switch over to G-LOC pads.

ALSO! I learned that my buddy went through TWO sets of z1 2-piece rotors in a matter of a year due to hairline cracking. Keep this in mind when purchasing new rotors, I'd steer clear of z1 2piece!

__________________

Rusty

Once the stock VLSD gets hot. It's done for until it cools down. Repeated high temps will cook the silicone fluid inside of it. Mine would go open after about 10 minutes of track use.

If you get the OS Giken diff. only use the OS Giken gear lube for it unless you like noise and strange behavior.

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html

Rusty

I have the RacingBrake 2 peice rotors. They are $$ but are worth it so far. On the 3rd set of pads and the rotors have never been cut or trued.

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html

Zewerr

Even though my car only has 33k miles, my VLSD is likely 100% toast. If feels like a wide open diff on all my runs, even on really cold days.

I'm currently on Z1 two piece, as well, drilled+slotted. If I end up with issues with the drilled, I'll probably just swap to slotted or sprinkled, only.

///maestro

My buddy, Austin Hertel, went through two sets of z1 2-piece rotors in a matter of a few months (like 3 track days). Both cracked in the exact same spot. Z1 refused to replace the second set. He literally used up .011mm of the rotor when it cracked. I’d steer clear of z1 2-piece rotors if you track your car. Z1s “excuse” is that he used them in very cold temperatures lol.....

__________________