![]() |
Cleaned off the fender liners and got them put back in: Headers going in! They fit with room to spare. They are ceramic coated and look great. Got the driveshaft
|
|
LinkBack | Thread Tools | Display Modes |
![]() |
#11 (permalink) |
Base Member
Join Date: Dec 2011
Location: St. Louis
Posts: 83
Drives: 2004 350Z
Rep Power: 19 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
Cleaned off the fender liners and got them put back in:
![]() Headers going in! They fit with room to spare. They are ceramic coated and look great. ![]() ![]() ![]() Got the driveshaft installed as well: ![]() I started doing some wiring up front. I had been putting off doing some of the tedious work of trying to hide some of the fuse boxes, and tackle the front headlight/horn harness. I was a long process getting the front section back in and hiding everything. I started with a huge mess and ended up cleaning it up quite a bit: ![]() ![]() Tucked the front fuse box under the crash bar. I will only be using two of these relays in the end after everything is functioning: ![]() Horns mounted: ![]() I hid the fan relays in each fender liner. I tucked them in the little plastic crevice and ran the wires through the back with a little grommet: ![]() ![]() ![]() I ran some 10g wire all the way to the back and hid the fuel pump relay in the compartment where the spare tools went. Should feed some power to the Walbro 400 nicely ![]()
__________________
![]() |
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
CA 93 RX7 FD3S with mods 14.5K OBO | kensin0429 | Other Vehicle For sale | 5 | 10-25-2012 05:28 PM |
Re-Amemiya Twin-Turbo RX-7 FD3S Build | issforged | Other Vehicles | 3 | 04-17-2012 10:22 AM |
help with a powered sub | sonic370 | Audio & Video | 19 | 09-15-2011 10:43 AM |
new z mercedes powered? | edub370 | Nissan 370Z General Discussions | 18 | 08-13-2011 11:23 AM |
f/s hks hi powered exhaust | nismo42 | Parts for sale (Private Classifieds) | 15 | 02-23-2011 12:29 AM |