|
To disconnect the sensor, you just need to remove the front passenger wheel and fender liner. There is a connector near the top of the reservoir right next to where
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-19-2020, 07:42 PM
|
#2 (permalink) |
|
A True Z Fanatic
Join Date: Mar 2011
Location: Austin, TX
Age: 44
Posts: 36,450
Drives: 11 Z34, 98 E36 M3
Rep Power: 2684441   |
To disconnect the sensor, you just need to remove the front passenger wheel and fender liner. There is a connector near the top of the reservoir right next to where the filler neck inserts into the main reservoir body. If you disconnect this connector, you disconnect both the washer pump and the washer level switch. The extension harness going to the bottom of the reservoir is for the washer level switch (the other goes to the pump which should be obvious). Not terribly difficult.
However, I'm not sure disconnecting it will disable the warning light.
__________________
 2011 370Z 6MT Sport Gun Metallic | ARC | CJM | Ecutek | FI | Fujimura | R2C | SPL | Stillen | TWM | Z1 | ZSpeed | |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help, Windshield Washer tank level sensor connector. | 2011 Nismo#91 | Exterior & Interior | 1 | 09-10-2021 07:37 PM |
| windshield washer | kensnismo | Exterior & Interior | 13 | 11-07-2012 09:36 PM |
| What does bosch sensor disable? | djtodd | Track / Autocross / Drifting / Dragstrip | 2 | 07-17-2012 12:45 AM |
| Washer Fluid Reservoir Level | axio | Nissan 370Z General Discussions | 15 | 10-18-2011 01:05 AM |
| Disable motion/speed sensor? | Mhaddy | Audio & Video | 9 | 04-12-2010 04:01 PM |
2Likes
Threaded Mode
