Thread: How to Disable Windshield Washer Level Sensor Dash Light/Notification
View Single Post
Old 03-19-2020, 07:56 PM   #3 (permalink)
RickyBobby
Base Member
 
Join Date: Apr 2014
Location: Hawaii, USA
Posts: 52
Drives: 15 Nissan 370Z Base
Rep Power: 3366
RickyBobby has a reputation beyond reputeRickyBobby has a reputation beyond reputeRickyBobby has a reputation beyond reputeRickyBobby has a reputation beyond reputeRickyBobby has a reputation beyond reputeRickyBobby has a reputation beyond reputeRickyBobby has a reputation beyond reputeRickyBobby has a reputation beyond reputeRickyBobby has a reputation beyond reputeRickyBobby has a reputation beyond reputeRickyBobby has a reputation beyond repute
Default
Quote:
Originally Posted by JARblue View Post
To disconnect the sensor, you just need to remove the front passenger wheel and fender liner. There is a connector near the top of the reservoir right next to where the filler neck inserts into the main reservoir body. If you disconnect this connector, you disconnect both the washer pump and the washer level switch. The extension harness going to the bottom of the reservoir is for the washer level switch (the other goes to the pump which should be obvious). Not terribly difficult.

However, I'm not sure disconnecting it will disable the warning light.

Thank you for the reply. Is it possible to disconnect the extension harness for the level sensor at a connector up at the top of the reservoir, or would I have to disconnect it at a connector located on the sensor at the bottom of the reservoir?
RickyBobby is offline   Reply With Quote