Cold Start Question

Whitey#1 · 09-17-2009, 06:21 AM

just wondering how long you other Z drivers let the car run before putting it in gear? basically i am referring to a cold start here.

in the mornings when i am going to drive it into the office i usually will start it and let it run at least 30 seconds before sticking the A/T into Reverse to back out of the garage.

how long do you guys usually let a cold engine run before engaging the transmission?

Mike

370Zwolf · 09-17-2009, 07:01 AM

I noticed that my Z has higher idle rpms (around 1500) for the first 30-60 secs after startup.
However, I don´t let it warm up in idle before backing out of the garage.
It´s just noticeable that I can back up easily with no throttle (6MT) due to the higher idle rpms.
When I get out again to close the garage door, he gets some more time in idle anyways.

When driving, my own personal warmup rules to baby the engine are:
- no more than 2000 rpms until the engine coolant temp gauge is fully up (which happens quite quickly, noticeably faster than in my other cars)
- no more than 3000 rpms until the oil temperature is up in normal ranges.

Thereafter, I´m good to go except for still being in break-in phase and thus limited to 4000 rpms...
Looking forward to hitting the redline for the first time after break-in, but it´ll get an oil change before that.
I know I haven´t yet experienced all the exciting moves and sounds this car has to offer.

kenchan · 09-17-2009, 07:19 AM

see below...

kannibul · 09-17-2009, 07:43 AM

Quote:

Originally Posted by Whitey#1

just wondering how long you other Z drivers let the car run before putting it in gear? basically i am referring to a cold start here.

in the mornings when i am going to drive it into the office i usually will start it and let it run at least 30 seconds before sticking the A/T into Reverse to back out of the garage.

how long do you guys usually let a cold engine run before engaging the transmission?

Mike

I let it run until the RPM's start to drop. It's about 20-30 seconds.

I started it the other day and it had what felt like a rough idle upon starting - it stopped doing that after about 10 seconds =/

I've got a G3 intake on it, but not other mods. Maybe the G3 is in too tight or something crazy like that (no way should it be a rough idle - temps have been fine, etc)

Cjanik · 09-17-2009, 07:50 AM

I wait until the engine temperature gets about 3 or 4 notches away from cold. (30-60 seconds).

Then I dont exceed 3,000rpm's until its in the "warm" position.

and I dont floor it (nothing over about 4-5,000rpm) until the oil temp is at least 180.

Modshack · 09-17-2009, 08:27 AM

Quote:

Originally Posted by Cjanik

I wait until the engine temperature gets about 3 or 4 notches away from cold. (30-60 seconds).

Then I dont exceed 3,000rpm's until its in the "warm" position.

and I dont floor it (nothing over about 4-5,000rpm) until the oil temp is at least 180.

FYI, The "fully warmed" LED lights up at 155 degrees and stays on that same light until past 210 degrees.. I's a pretty worthless "Gauge"

semtex · 09-17-2009, 08:50 AM

30 seconds. And it just so happens that my Blinder beeps after it goes through its startup self-check routine, which lasts exactly 30 seconds, so as soon as I hear that beep, that tells me I'm good to go.

billydsz · 09-17-2009, 09:33 AM

The owners manual states you should wait 30 seconds after starting before putting the car in gear.

spearfish25 · 09-17-2009, 10:03 AM

30 seconds for your blinder to do its self check!!! That would annoy the $hit out of me.

Quote:

Originally Posted by semtex

30 seconds. And it just so happens that my Blinder beeps after it goes through its startup self-check routine, which lasts exactly 30 seconds, so as soon as I hear that beep, that tells me I'm good to go.

kenchan · 09-17-2009, 11:22 AM

Quote:

Originally Posted by billydsz

The owners manual states you should wait 30 seconds after starting before putting the car in gear.

you are correct:

4. Warm-up
Allow the engine to idle for at least 30
seconds after starting. Do not race the
engine while warming it up. Drive at
moderate speed for a short distance first,
especially in cold weather. In cold weather,
keep the engine running for a minimum of 2 -
3 minutes before shutting it off. Starting and
stopping the engine over a short period of
time may make the vehicle more difficult to
start.

semtex · 09-17-2009, 11:34 AM

Quote:

Originally Posted by spearfish25

30 seconds for your blinder to do its self check!!! That would annoy the $hit out of me.

Why? It comes on right away, and emits a small beep 30 seconds later. What's the big deal? It's not like the car is immobilized during that 30 seconds or anything.

spearfish25 · 09-17-2009, 12:38 PM

Quote:

Originally Posted by semtex

Why? It comes on right away, and emits a small beep 30 seconds later. What's the big deal? It's not like the car is immobilized during that 30 seconds or anything.

I thought you had 30 seconds of random beeping during the self-checks. My passport 9500ix has about 5 seconds of different chirps but it's enough to almost start annoying me.

semtex · 09-17-2009, 01:08 PM

Quote:

Originally Posted by spearfish25

I thought you had 30 seconds of random beeping during the self-checks. My passport 9500ix has about 5 seconds of different chirps but it's enough to almost start annoying me.

Ahh...lol.. yeah that would be annoying as hell. I know what you mean, my V1 goes through all these beeps during the startup. Thankfully the Blinder isn't like that.

6MT · 09-17-2009, 01:25 PM

The increased idle that you mention at cold start-up is the ecu "waiting" (can't think of a better word, sorry) for a signal from the oxygen sensors. Once they've gone closed loop, the idle comes down. Usually only takes less than a minute. After that, it should be ok to give-'er!

GingaBreadMan · 09-17-2009, 01:31 PM

I usually wait til the rpm's are at 1k or below.

09-17-2009, 06:21 AM	#1 (permalink)
Whitey#1 Base Member Join Date: Jul 2009 Location: Loogootee, IN Posts: 78 Drives: 09 MB/Frost 370Z AT Rep Power: 15	Cold Start Question just wondering how long you other Z drivers let the car run before putting it in gear? basically i am referring to a cold start here. in the mornings when i am going to drive it into the office i usually will start it and let it run at least 30 seconds before sticking the A/T into Reverse to back out of the garage. how long do you guys usually let a cold engine run before engaging the transmission? Mike

09-17-2009, 07:01 AM	#2 (permalink)
370Zwolf Base Member Join Date: Aug 2009 Location: Erding - City of Beer Age: 48 Posts: 77 Drives: 370Z Pack 6MT BP Rep Power: 15	I noticed that my Z has higher idle rpms (around 1500) for the first 30-60 secs after startup. However, I don´t let it warm up in idle before backing out of the garage. It´s just noticeable that I can back up easily with no throttle (6MT) due to the higher idle rpms. When I get out again to close the garage door, he gets some more time in idle anyways. When driving, my own personal warmup rules to baby the engine are: - no more than 2000 rpms until the engine coolant temp gauge is fully up (which happens quite quickly, noticeably faster than in my other cars) - no more than 3000 rpms until the oil temperature is up in normal ranges. Thereafter, I´m good to go except for still being in break-in phase and thus limited to 4000 rpms... Looking forward to hitting the redline for the first time after break-in, but it´ll get an oil change before that. I know I haven´t yet experienced all the exciting moves and sounds this car has to offer. __________________ "For once you have tasted flight, you will forever walk the face of the earth with your head turned skywards, For you will forever long to be up there again where you once have been." - Leonardo DaVinci

09-17-2009, 07:19 AM	#3 (permalink)
kenchan A True Z Fanatic Join Date: Aug 2009 Location: N/A Posts: 76,801 Drives: N/A Rep Power: 141520	see below... Last edited by kenchan; 09-17-2009 at 11:23 AM. Reason: bad info given... see below 30sec is in the manual

09-17-2009, 08:50 AM	#7 (permalink)
semtex A True Z Fanatic Join Date: Jan 2009 Location: Behind enemy lines Age: 53 Posts: 5,995 Drives: People to drink Rep Power: 32	30 seconds. And it just so happens that my Blinder beeps after it goes through its startup self-check routine, which lasts exactly 30 seconds, so as soon as I hear that beep, that tells me I'm good to go. __________________ "There are no small accidents on this circuit." -- Ayrton Senna 316.8whp & 248 ft/lbs (Dyno Dynamics) \| 319whp & 256 ft/lbs (DynoJet) (04/23/10) Stillen G3 CAI, CBE, Pulley / F.I. LTH / GTSpec Ladder Brace / Setrab Oil Cooler / UpRev-tuned by Forged Perf.

09-17-2009, 01:25 PM	#14 (permalink)
6MT A True Z Fanatic Join Date: May 2009 Location: ITU Zone 2 Posts: 22,459 Drives: Reliant Robin Rep Power: 1789	The increased idle that you mention at cold start-up is the ecu "waiting" (can't think of a better word, sorry) for a signal from the oxygen sensors. Once they've gone closed loop, the idle comes down. Usually only takes less than a minute. After that, it should be ok to give-'er! __________________ Andrew 2009 370Z Sport/Touring 6MT sold 2013 Honda Civic Si coupe D/D

09-17-2009, 07:50 AM	#5 (permalink)
Cjanik Track Member Join Date: May 2009 Location: Las Vegas Posts: 578 Drives: N/A Rep Power: 16	I wait until the engine temperature gets about 3 or 4 notches away from cold. (30-60 seconds). Then I dont exceed 3,000rpm's until its in the "warm" position. and I dont floor it (nothing over about 4-5,000rpm) until the oil temp is at least 180.

09-17-2009, 09:33 AM	#8 (permalink)
billydsz Enthusiast Member Join Date: Aug 2009 Location: New Bern Posts: 252 Drives: 9 370z SptCp SRd 7AT Rep Power: 15	The owners manual states you should wait 30 seconds after starting before putting the car in gear.

09-17-2009, 01:31 PM	#15 (permalink)
GingaBreadMan Enthusiast Member Join Date: Jun 2009 Location: New York Posts: 313 Drives: 09 370z Sport 6spd Rep Power: 15	I usually wait til the rpm's are at 1k or below. __________________ ClearBra/Debadging/Tinted Head & Taillights Coming Soon:180° Customs Headlights/ISS Forged Spyder 19" 265*305/Swift Springs/STS Rear Mount Turbo

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
remote start ?	Wicked Nestor	Nissan 370Z General Discussions	27	04-28-2011 04:25 PM
Remote start	av370	Nissan 370Z General Discussions	38	02-09-2011 06:12 PM
Remote start	cwj370	Nissan 370Z General Discussions	24	09-15-2009 07:16 PM
question about the push start button.	juan05	Nissan 370Z General Discussions	26	08-28-2009 02:28 AM
Notchy 2nd gear after cold start?	jmlenz	Nissan 370Z General Discussions	11	08-21-2009 08:17 PM