What did you do with your Z today VI (ON TOPIC DISCUSSION ONLY)

wolfcyn

i sprayed down my demon bolts with some WD-40 in preperation for tomorrow evening. hopefully i dont have too much trouble lol.


Sent from my iPhone using Tapatalk

Silly Rabbit

Good Luck

__________________
NISMO R Tune Intakes \ Fast Intentions RHFC \ Borla CBE \ EcuTek Tuned\ SPL Camber Arms \ Powertrix Coilovers \ Swift Springs \ Avant Garde \ Wicked CAS \ Morimoto XB Halos \ Custom Fenders \ Hotchkis Sways \ NLP Splitter

JARblue

Good luck man

FWIW, WD-40 is really more of a lubricant ... its does have some penetrating power due to its low surface tension. But the WD-40 Specialist penetrating product (or something like PB Blaster) is going to work much better

__________________

wolfcyn

can i find it at an autozone of some sort?


Sent from my iPhone using Tapatalk

JARblue

Absolutely. Any autoparts store should have some PB Blaster for sure. I'm not sure if they carry the WD-40 Specialist line of products.

__________________

Jayhovah

I just went out to buy some penetrating oil yesterday - Walmart carries both the WD-40 "blue torch" oil as well as PB Blaster. (I bought PB since that is what I haved used forever)

Do you have experience with the WD-40 penetrating oil? Better than PB you think?

__________________
2013 Gun Metallic Sport - Gamma V3 Twin Turbogized
DIY Gamma V3 TT Install * Jayhovah's Gamma V3 TT Install Pic'Z and Vid'Z * DIY: Washer Reservoir for the Boosted

JARblue

Not personally, no. My guess would be they aren't significantly different. PB Blaster has always worked fine for me, so I wouldn't think the WD-40 stuff is that much better.

__________________

wolfcyn

just scooped some pb blaster up. imma spray the bolts down again every day until tuesday


Sent from my iPhone using Tapatalk

DeliriousClam

If you want a truely kickass penetrating oil, use a 50/50 mix of ATF and acetone. Otherwise I suggest liquid wrench over both PB and WD-40

__________________
Stillen, AAM, Shine Auto, Fujimora, Swift, EVO-R, Carbon Fiber Element, Nitrous Outlet
MECP Advanced: CEA26671
Most of what I post here are artistic works of fiction and falsehood. Only a fool would take anything I post here as fact.

wolfcyn

well, i just wanna say, F*** the demon bolts. they reall are a pain to get to. Especially the driver's side bolts. Passenger side was very simple and not hard at all to break loose. hopefully imma finish up tomorrow. anyone care to give me any advice on the driver's side?

astro932

i broke an extension trying to get the drivers out... impact extensions helped a ton

__________________

Jayhovah

Did you remove the intakes so you could reach them without swivels? On the drivers side using a bolt extractor, long extension, and huge breaker bar I was able to get enough torque to snap the stud.

Sent from my Nexus 6 using Tapatalk

__________________
2013 Gun Metallic Sport - Gamma V3 Twin Turbogized
DIY Gamma V3 TT Install * Jayhovah's Gamma V3 TT Install Pic'Z and Vid'Z * DIY: Washer Reservoir for the Boosted