oil cooler

ImportConvert · 04-28-2011, 10:31 PM

Quote:

Originally Posted by Dark Sarcasm

Ok, once again, youre trying to relate GM to the Z. GM had problems with oil coolers and redesigned their crap, [sarcasm] SOOOOOO every oil cooler must be crap and therefore not used until it matches GMs far superior engineering. [/sarcasm]

220+ degree oil temps in a Z is not healthy for an engine, IMO. From an engineering standpoint it might be fine. Either way, I DONT GIVE A F*** about GMs experiences with oil coolers on Vettes.

-220* oil temps are just fine.

-This is a discussion about engines and oil and manufacturer names are just incidental.

-Plate style coolers tend to over-cool the oil. Further, unless you install a bypass for them, they aren't the safest setup. You can of course install a thermostat or buy a plate cooler with a thermostat in it, but the point remains that you are doing this because in your mind 220* oil temps are too hot.

-Check your "IMO" at the door IMO is worthless in a technical thread. For once try to support your emotionally charged BS with fact instead of Fanboi nonsense.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved)	djpathfinder	DIY Section (Do-It-Yourself)	21	11-30-2015 05:47 AM
Nissan Motorsports Oil Cooler vs. Stillen Oil Cooler	Dustin@Z1	Engine & Drivetrain	158	03-10-2014 02:27 PM
STILLEN oil cooler kit + STILLEN power steering cooler = fit?	ZBW39	STILLEN	2	07-02-2010 01:08 PM
Oil Cooler.....Trans Cooler...	kannibul	Engine & Drivetrain	6	12-31-2009 06:32 PM