|
Once I lowered on swifts, it was a nightmare. Barely squeezed my HF jack in the rear. Then had to screw around on all sides to get the front up.
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
05-08-2017, 12:44 PM
|
#29 (permalink) |
|
A True Z Fanatic
Join Date: Mar 2015
Location: Some Place Cold
Posts: 16,060
Drives: In Circles
Rep Power: 2684397   |
Once I lowered on swifts, it was a nightmare. Barely squeezed my HF jack in the rear. Then had to screw around on all sides to get the front up. Even worse when I only had 2 stands with me.
I bought these since I'm not paying $300+ for race ramps and extensions. https://www.amazon.com/Discount-Ramp...ords=car+ramps They barely fit under the front chin and give just enough coverage to get my normal hydraulic jack completely under the front of the car to the nipple. If you are lower than just adding swifts, raceramps will be the way to go. Jack the sucker up and I use 2 notches roughly on the stands. Anything higher and I start to question if the $90 special from HF will hold up hahahahahaha.
__________________
I AM FLOOF! SOMEBODY FLOOF MY HORN!! ALL HAIL THE FLOOF!!I JUST FLOOFED ON THE FLOOR |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| best floor jack for working on front and rear of 370z | gsxr750 | Nissan 370Z General Discussions | 35 | 09-12-2013 10:28 PM |
| Super Low Profile Floor Jack on sale for cheap | Sh0velMan | Nissan 370Z General Discussions | 37 | 04-15-2013 08:54 AM |
| Actual picture of 370z supported by jack stands on all 4 side jack pionts. | gsxr750 | Nissan 370Z General Discussions | 2 | 10-28-2012 02:42 PM |
| [WTB] Factory 370z Floor Mats or Aftermarket all weather floor mats [SOCAL] | kday | Parts for sale (Private Classifieds) | 4 | 06-27-2012 03:20 PM |
| Jack Stands / Floor Jack | ronaldr911 | Exterior & Interior | 31 | 01-10-2012 01:50 PM |
27Likes
Threaded Mode
