The kit install itself is not bad at all. I would estimate it would take good weekend (25 hrs) If you have all your tools lined up. I approve of the kit's design. The instructions for the most part is clear. There were some areas that I couldn't follow but you could post and ask for help. Quite a few people have taken on the task so there are people who can help. SASHA is pretty good with respond to e mails And pm's. I would rate the turbo install itself a 6/10.
List of things to have ready:
-clutch and flywheel to handle power goal
-tools, sockets, lots of extensions, wobble bits, large adjustable Cresent wrench
-safe flat surface and Jack stands
-some lube ( I used water based like KY) to lube up the couplers so they slide together easier
-good light to see around in
-make sure you can get the cat off
-soldering iron and shrink wrap
Hey YzGyz! I was just looking at your build thread and I was wondering how the installation of your BP turbo was and any initial thoughts or comments on the setup in general?
Likes Received
