synolimit

Hello, Are you still porting TB'S? Thank you.

Hello, Are you still porting TB's? Thank you.

Hi, Synolimit. I was reaching out to get some info about porting manifolds, but another member told me you haven't been active on this forum for a while. Seeing the other messages on your profile let's me know you've been inactive for quite some time. I hope everything is OK and you are doing well!

This is your id scott? Just say hi!

there are people trying to get hold of you. Me too eventually when u have a manifold ported since the car is my DD. Hope all is well

i saw on a post that you are running obx long tube headers. You mind giving me a full review on them like whp, torque, and installation etc? i was thinking about getting those myself.

Hey man I have 2 bnib driver side throttle bodies for sale if you're interested. I bought one left and one right but they sent me two driver's side tbs and this was the same week my mother passed and I didn't get around to returning the one in time then found out I didn't need either one in the first place. Make an offer I'll do them for a good price

so you have obx lth did you had to do any mods other than tuning? ex: extending 02 sensor? or something else?

hey，im sheng，i want ask u how GT wing R u use ？

Hello,

would you meet half way from dulles at wheeling WV?
jb

PPG do gearboxes ..... In terms of gearboxes ... I already have a Holinger HS6 in stock ... just waiting for all the other stuff to arrive (budget-bound at present, so it is a case of making...

Also, check your local motor vehicle inspection laws. Many states will fail you if your airbag light is on or your seat belts are not standard. You may need to solder in a resistor to turn off the...

I'm really digging your DIY hood man. Care to pm me sole details and measurements and grill used? Thanks:tup:

I don't think that's the problem. Honestly OP, I know you track a lot, but you gotta start tracking without using your brakes as often. That's the issue I'm seeing... And/or the ducts aren't properly...

post #4

This very issue happened to me at the track once. My brake fluid was just real low. I had just trashed a set of pads

How much you wanna pay me to pick it up and ship it?

IQ test fail in Midwest?

Already running a set of single adjust AST dampers. Still using the factory Nismo springs though.

Yes. I like it. With -3.2 camber also. Not cause of rubbing issues. It clears by miles.

I'll have to find them. There not on the forum. Forged Performance done one. It's really simple in theory.

I have the WLs installed in my Z now. Was a pain to get the sub-frame stock one out but you can really tell the difference and they are not to loud compared to the solid Aluminum ones. Defiantly a...

This was my solution for geting oil pressue & water temp http://www.the370z.com/members/felix-808-albums-galeforce-gauge-pod-picture73474-dsc02300.jpg

your book is screwy... so Nissan is stupid for running a 285/35 on the rear nismo rims? :rolleyes:

Okay... last post, but this is the sh1ttiest video ever. You can make out the 50 mph marker, and 100mph is when it bounces off the limiter. I took TCS off and I tried a ghetto mount but the effing...