SonicVQ

Hey!
I guess you are here to find out more about me... so here goes

I drive a G37 Sport Sedan (rear wheel drive, 6 speed manual) and have a background in electronics, auto mechanics, vehicle networks (CAN bus), C/C++ programming and micro controllers.

Most of my time is spent on automotive research (Nissan/Infiniti) and trying to help others.

Thanks for dropping by!

Interesting problem... From the FSM under P0500: The vehicle speed signal is sent to the combination meter from the “ABS actuator and electric unit (control unit)” via the CAN communication line....

Interesting problem... From the FSM under P0500: The vehicle speed signal is sent to the combination meter from the “ABS actuator and electric unit (control unit)” via the CAN communication line....

The bluetooth module on the EcuTek device is different than the bluetooth modules used on most OBD modules, the TI CC2540 "system on chip" (SOC). EcuTek module supports bluetooth 4.1 and...

I am in the process of adding a oil filter sandwich plate to monitor the oil pressure and temp. In looking at the flow of oil, the oil pressure sensor in the sandwich will measure the oil pressure...

Excellent video! Short and to the point.

Excellent add! Note: This older style and larger oil pressure sensor uses a flexible tube/bellows to push/pull a wiper/contact across a wire wound resistor. This results in a resistance of 3-160...

There is a third option: Remove the low oil pressure switch (it turns on the light at < 5 psi!!) and install the gauge. As I see it, since you have a pressure gauge, you can detect low oil...

With an oil pressure sensor/gauge, there is no need for the factory oil pressure switch. Here is why: • The oil pressure switch turns on the idiot light when oil pressure is < 5 psi. (tested &...

Over the last 10+ years, engine coolants have become very specialized. AND in some cases if you add the wrong type/technology it can turn to a gel. Even when you drain all the coolant out, there...

Over the last 10+ years, engine coolants have become very specialized. AND in some cases if you add the wrong type/technology it can turn to a gel. Even when you drain all the coolant out, there...

Over the last 10+ years, engine coolants have become very specialized. AND in some cases if you add the wrong type/technology it can turn to a gel. Even when you drain all the coolant out, there...

You may want to move your pressure gauge to the 1/8 BSP port on the engine block. The engine oil pressure inside the engine = 35psi - (oil cooler & lines pressure drop) - (oil filter pressure...

You may want to move your pressure gauge to the 1/8 BSP port on the engine block. The engine oil pressure inside the engine = 35psi - (oil cooler & lines pressure drop) - (oil filter pressure...

You may want to move your pressure gauge to the 1/8 BSP port on the engine block. The engine oil pressure inside the engine = 35psi - (oil cooler & lines pressure drop) - (oil filter pressure...

Right here: https://www.nicoclub.com/nissan-service-manuals