redondoaveb

Hey man, love your build! You've inspired me to build mine! I'm going to go for a Tomei with cat deletes and maybe some red JNC wheels like yours!

Hey brotha,

Currently installing the topgunz SC kit, and going the route of installing a external wastegate to help with in cabin boost control...Saw on one of the threads you went the same route...you happen to have a picture or explanation of this? just dont want to cut into the wrong piping if their is a better placement as its pretty tight in our bay with this kit

What size is your walbro fuel pump?

Hello, you said you followed me on Insta, what is your instagram?

Which Southbend Clutch are you running, and would you recommend it for a daily driver? I am ordering parts for my ACE Supercharger set up, and I am having a hard time with picking a clutch. I will be running e-85 and anticipate getting 420-460 rear wheel torque. I have a 10 mile daily commute in Chicago traffic.

Hey man, I finally received the switch. I have a question about your wiring. It's been a while since my electronics class so, bear with me. How did you wire up the switch to enable the halo light as well?

I'm guessing Common is connected to one end of the spliced Yaw Sensor Wire, and the other end is connected to Normally Closed. How did you wire up the halo light on the switch? Thanks for any help.

Clearance issues. :mad:

Installing the Raceworks Diff Brace from Z1. Save your money. It's bad. I tried installing mine tonight. If you have exhaust like FI. You have to trim about 1 3/8" off of the corner of the brace...

I run 2000's and idle is fine... this is an old notion. get the 1700's and have fun. ID1700 can idle like stock.

This is Ben Blackwell's motors that will be shooting for around 900 wheel with our air to air conversion and the YS7 blower from vortech. This motor does not have any upgraded cams, just our stage 2...

You guy need to move...oh I guess you can't go outside until the spring thaw! It's 63 and sunny!!!!!!! Sent from my SM-G965U using Tapatalk

I wish I could get my car to Seb to be finished. I keep hitting snags. Last week went to do my second round of WOT logs on map 3 and dammit if I didn't blow out a flange gasket mated to the turbo...

I don't tell about it! I need to boycott this thread. Sent from my SM-G965U using Tapatalk

I should have mine in 2 days.

My motor is broke but my rear diff is good to go! Sent from my SM-G965U using Tapatalk

Ha ha you guys are going to make me spend money. Sent from my SM-G965U using Tapatalk

Mine should be here this week. :tup:

Just ordered the Z1 Bell Raceworks diff brace.

That's the key. If he has the items in stock, everything goes fine. If they're not in stock (good luck figuring that out on his website), then grab your ankles. It's really frustrating since his...

You probably didn't need to start a new thread on this topic. Try cutting a slit in a hockey puck. Or check out either one of these threads for additional information. ...

When I got mine I was like "okay let's see how they put a 12" woofer in this thing". The entire driver has a whole through the middle of it, like a donut. Pretty neato, I hadn't seen that before. ...