overtureZ

It has not been repainted since the conversion was finished in March 2016. The hood, bumper, and fenders will need to be repainted. Mine is daily driver and accepted that it is part of deal. Everything else look great.

It's a rock chip magnet.

LOL. That's the way it is.

Hey man. Let me know what's going on and I'll see if I can offer any input. Let me know the specs of the car and what's going on. The biggest problem I had was the tps sensor and I insulated it with their "new" sensor that doesn't have the issue anymore.

Aside from that the O2 sensor throws codes for a bad cat if it goes bad but that just gives me a loss of HP sometimes if the sensor decides to be sassy. I went on a trip and my battery couldn't hold a charge which caused problems.

New sensor, new battery, new sensor, car back to new.

I'll be more active so I can get back to you.

When I was NA, I was at 315/268. I am still working through the tune on my SC build and then I'll be able to get some numbers up for it as soon as I can get to a dyno.

My side skirts are from the zele kit...we had to use thos to match up with the wide body kit because the amuse sides wouldn't jive with the fenders

Can't wait til you post up the time slip When you going?

don't stop at just the time slip. put down that pink slip for the race. You're about to win yourself a new family car.

Take it to the track. It should be a close race though depending on how is the better driver good luck. With the Dodge Charger SRT8 it can't out run ugly and the Dodge Charger SRT8 is one of the most...

plot twist: he's got NOS under the passenger seat.

Pretty sure you'll blow him away. Ramp up your $ bet for a solid payday!

Im pretty sure it just runs do dump on ground if it were to blow off it would mist or possibly drain coolant and you dont want that on your motor/headers so route it to street.

Guys, I've had a bunch of inquires about my additional pulley kit again. Right now I'm out of stock on several of the parts needed. If you are wanting one of my kits please PM me so I can get the...

Are you going with the Si trim and the 9psi pulley on the water setup? We all know the outcome of that combination...

Yes it absolutely was...and I am dreading having to take it off to relocate my maf sensors. A little wd-40 around the inside helps alot (but its still a big B).

Did you already tighten down the throttle body couplers? Loosen those up, fit it all up, then tighten.

1. Turbosmart BOV was a popular upgrade with the standard kit. Use in place of original Bypass valve. No different steps needed. 2. Original connector from harness reaches one of them just fine....

Precision was absolutely brutal when it came to this sort of stuff. I covered installation damages from my own pocket for customers on Precision turbos. No matter what, they always say: "It's oil...

agreed, i would never trust a shop to do this cleanly, i don't trust people with my car lol

No, it still has to have the bosch valve. It is there in addition for the sound. Probably causes a terrible hiccup and stutter in the throttle decell.

It's actually in the instructions. If I were at home I could get it to you. It's just the wiring of the relay from the fuel pump to I believe the fuse marked washer behind the battery. But I could...