Optimiser

Sent you an email

Hi there,
Sorry don't have those socail media accounts but you can email me at pcoptimiser@optusnet.com.au
My car is actually at Revzone now getting some more things done. happy to discuss with you.

Hey buddy, do you have discord or facebook?

Would like to chat you about your build. I'm from Australia buying the stillen supercharge kit with some upgraded components. Getting it tuned at Revzone next month.

Okay, I've tried searching for this, but it seems the usual reply is 'use a calculator!', and no one seems to come back and actually state what results they got. I don't know about them specifically...

Akebono is fine for track days, going full-on race competition requires Alcon/AP Racing/Stoptech race. I have used Akebono for many many track days, and cold-firing rotors helped with both bite...

I actually found the solution after another attempt. Same procedure, but instead of tapping into the white wire marked "ILL (-)" that connects to the Bose audio unit through connector M81, you need...

I just dropped my trans myself and has this issue after. I read through the fsm because i knew changing the trans fluid couldn't cause this. There is a procedure when reassembling the shifter. When...

Should I assume the answer to my question is a "no"? :(

Will you take sexual favors in exchange for one of these systems?

4k8taKz_V9o

Sorry everyone, it's be a hectic last couple months. Here's where I am at currently: So the ROM viewer/editor is nearly complete. Right now there are a couple things left to do. 1) Combine...

So I've been working on developing an open source tuning suite over the last 6 months or so. I started in Java, i got a lot of the way through development before i decided that i should switch to...

Got the spacer made today. It had been awhile since I got to use my lathe.

As mentioned in my last post, I did design a custom step spacer for mounting this additional idler pulley. This spacer sets the correct spacing with out using a stack of washers and eliminates having...

I used the NAPA pulley that Pauly Z found for us: Pulley- 54 mm #36375 Belt- Micro V 6 rib #061093 OR MODIFIED K081088 along with a 12x1.75x50mm bolt, a 12x1.75mm hex nut and 6ea. 7/16 inch...