old guy

Nope.......just wrapped the empty plugs in plastic to prevent water getting in. I also bought gutter leaf guard at the big box store, (it's steel dipped in plastic, still looks good after years) to dress the empty holes. ( Cut to shape, and Installed from behind the facia with JB Weld. )

It is a pain in the rear end, especially when life demands attention every 20 minutes. :icon17:

and internet. family dog car fresh air

SUP!! Thanks for the warm welcome back. I missed everyone... and land.

I should be rolling my sub-frame back under the Z on Friday. :tup:

Sup everyone!

Nah, it has been too cold to work outside.

Here's a good pic of the diff and sub-frame. You could make a brace that's goes over the top of the diff, top 4 bolt holes. and bolt to the top of the sub-frame. That would really lock the diff into...

Well I got them off. Helps if you know how to use your tools. Had the impact set to the lowest speed thought it was the highest. Threw on some impact sockets and it was off in a few seconds.

:hello: mornin'

ToolDay:tup: just a small one

But on a positive note, my parts guy from kenjigarage.com (shameless plug) called me saying my rotors are in. Will be picking up tonight. And UPS shows the rest of my calipers have been...

Today sucked... conference call after conference call after conference call, found out my services will be needed for the next few weekends.. GF is NOT going to be happy - shes in AZ to help out my...

Finally got my 5" Motordyne Burnt Ti tips on the car. Best part about the install was that I didn't even need to jack the car up. Exhaust tone has increased and is deeper than before. ...

Today I dug mine out.

And now the fun begins......