Elmo370z

Great buying experience on trader!!

Buying the BMW ABS unit that you suggested. Great solution at a fraction of the cost of a full Bosch racing ABS! I spoke to a race team running a 370Z who has it. They say it solved all the braking issues that haunt the stock 370z system. Thanks again for turning me on to it.

I’ll be at Sebring this weekend. Are you going?

Sorry, no shipping. The box weighs around 80 pounds

No prob; glad you're enjoying it!

I would like to know how it goes for you as well!

Where at. How much did it run you?

No, I had the shop do it and it's a bitch to do.

Yes I am.

Clean your mail box or get a prem. subsciption

Right on! There are none finer at tunning than Seb and he is a wealth of knowledge. It through a rod! Fatigue after five years of use and abuse. I was not surprised that it let go after three...

In three weeks it will be two years of waiting. My patience has turned into numbness. Sent from my SM-G965U using Tapatalk

What are you talking about? :icon14: You don't need any of that. It helps but not required :rolleyes:

Well there you go! You're good then. Get that shìt done and start :driving:

700whp is debatably within the realm of stock engine reliability, depending on how much you actually use it at that power and what you used it for. In the typical Z project setup, 700whp usually...

I’m running stock internals at 14 psi 612hp/511tq with 100% methanol injection since 2016 50k miles no issues

If you "only" want to push 650whp, i dont know if its worth it to go the mazworx route. No clue what Spooler paid but id be surprised if its anything below 15-20k. I run 602 whp on E85 with stock...

This is what comes with the kit: https://www.treadstoneperformance.com/trtt9-intercooler--twin-turbo-intercooler/p104596 This is a great core as well:...

This thread's been around almost as long as some of your FS threads :icon17:

In case you have not seen it. We offer a supercharger kit which makes just as much power, more torque (by utilizing the stock manifold) and removes all of the problems associated with the Soho kit,...

Yep kinda unfortunate.. I was quoted 15k USD which translates to 20.1k CAD before all the duties and fees as well.. A local place I found was quoting me 13k CAD.

Thanks for the details. The new lines are all crimped fittings, so no chance of leaks at elbow. The fitting now include dowty washers as well. So an improvement and correction to the issues you had.

So you got second hand information and fully intended to take that @ face value on a $10k decision? Glad you're ballin out like that. George, as in George Sohoritis told me the stage 2 kit will...

Be glad it’s not a bare block. Sent from my iPhone using Tapatalk

For all you diff cooler installing folks. This is what I have. HRNu1ytnrhE