Elmo370z

Great buying experience on trader!!

Buying the BMW ABS unit that you suggested. Great solution at a fraction of the cost of a full Bosch racing ABS! I spoke to a race team running a 370Z who has it. They say it solved all the braking issues that haunt the stock 370z system. Thanks again for turning me on to it.

I’ll be at Sebring this weekend. Are you going?

Sorry, no shipping. The box weighs around 80 pounds

No prob; glad you're enjoying it!

I would like to know how it goes for you as well!

Where at. How much did it run you?

No, I had the shop do it and it's a bitch to do.

Yes I am.

Clean your mail box or get a prem. subsciption

So today I spoke with Russ at Z1 and placed my order for the z1 power plenum and ported lower intake manifold with a new gasket for the mating surface between the lower intake manifold and the...

Your engine is way too modded to give anyone a gauge of a single mod, haha. You're a wildman (in a good way)!

My cams are being installed in the next 2 months on the 4.5 stroker. Z

Cams installed, all good, no CE light, temps okey. Will drive to dealers to adjust idle.

Elmo, Glad to hear from you. I hope you're enjoying your exhaust system and long tube headers. There is no need to worry; we use 304 stainless steel in building our exhaust components. 304...

Hell no man, my car has been strapped to a dyno for 4 days and the dyno has been broke for last two days. We cant figure out why it's not reading AFR so we can't tune the P.O.S.

looks like the exhaust has either a penis or a tumor hanging off of it lol

We tuned a 2014 base model 370Z manual with uprev earlier in the year and it made 337 hp and 265 tq.

I actually just came in to post an update. My ATI rep was finally back in the office. I have finalized the amount we need based on the group buy. They are now in coating and I have all the...

Well I finally finished the install. Stripped a bolt on the Cat support bar but just torched it out but damn did my buddies and I almost give up. Broke two extensions, then decided to get the thicker...

No one has that I recall. But very easy IMO. BASIC 1. Remove strut bar 2. Remove air intake 3. Unplug and remove throttle bodies. They do have a coolant line attached to them but won't leak...

Sure looks like the beginning of a potential problem. I'm sure the FI folks will chime in...

So I found a real crappy video from after we put them in. Hit up the customer to see if he can stop by one of these days. As for doing it in the car, we have done it. Saves you MAYBE 2 hours,...

I'm waiting for stage 2 to see the gains and how that sounds and also for a new manifold to go with and maximize it.

you know how I know you're gay............:shakes head: :bowrofl: