Elmo370z

Great buying experience on trader!!

Buying the BMW ABS unit that you suggested. Great solution at a fraction of the cost of a full Bosch racing ABS! I spoke to a race team running a 370Z who has it. They say it solved all the braking issues that haunt the stock 370z system. Thanks again for turning me on to it.

I’ll be at Sebring this weekend. Are you going?

Sorry, no shipping. The box weighs around 80 pounds

No prob; glad you're enjoying it!

I would like to know how it goes for you as well!

Where at. How much did it run you?

No, I had the shop do it and it's a bitch to do.

Yes I am.

Clean your mail box or get a prem. subsciption

Made 28 of them yesterday. Have to put together hardware kits for these though... theres a bit more than just the billet plate itself needed to get this all together and complete.

June Update .............. Porting now done, inlet flow is 328cfm at .600" lift with ITB fitted and WOT. This should equate to near enough 500hp @ the crank and we are hoping for 420+ atw ...

21. Vehicle: 2009 Nissan 370Z Nismo Transmission: Manual Modifications: Invidia Exhaust, Injen Intakes, & HFCs Fuel Octane: 93 ...

Yes I hate working with electrical stuff, I've never been great at it honestly. But I always try and figure it out. When I first got the Z I knew nothing, but I've never paid a shop to do any work...

It appears that you don't know a lot about cars or electricity. See if you can find a friend/relative/acquaintance that can read a wiring diagram and operate a pocket VOM. He/she can probably...

I wasn't told any specs figured they wouldn't tell me anyway if I asked. Only posted what I was told by JWT when I called yesterday nothing was made up. I have the C1's in my motor now waiting to...

So many rumors lol We have been working closely with JWT on both the C1 and C2s for the VHR engines. We will have the first few sets to test, and I will post results the same way I did with...

Material is on the way so I will be doing a big batch of these as early as this week, depending on when it arrives.

lol i don't have mine yet, but after owning the Z w/ just HFCs for a while i'm gonna have to agree. Then again i literally go to the range just to smell gunpowder and hear sh#t go bang.

I'm seeing what i can do. Wife needs a job so I have more of my money ;)

Allow me to nutswing for a moment. That is beautiful.

I'll never understand why people don't check the code and post it. Guessing a problem with no code is a needle in a haystack.

A set screw is what I currently had in mind. I will settle on the solution better tomorrow. Im going to use my heat gun to melt the stock rods out and then draw them into cad and see what i come up...

2. Dragonbreath For real. I'll send you money as soon as you start accepting lol.

I think we are looking at something in the $150 - 175 range. It will probably end up being really popular now that I think of it, because my 6-pin connector also accepts 12AWG wiring, and if you...