DrBacon

Enthusiast Member

Last Activity: 05-06-2025 12:51 AM

About Me

About DrBacon

Location

Washington

Drives

2014 Nismo

Statistics

Total Posts

Total Posts: 286
Posts Per Day: 0.09
Find all posts by DrBacon
Find all threads started by DrBacon

General Information

Last Activity: 05-06-2025 12:51 AM
Join Date: 11-10-2016
Referrals: 0

Friends

Showing Friends 1 to 3 of 3

Optimiser

Enthusiast Member
Spoiler

A True Z Fanatic
Zingston

A True Z Fanatic

Likes Received

260 Likes

redondoaveb liked post by DrBacon On thread : ***Topgunz ROTREX C38R Supercharger Kit***

Go with something full faced if you want to keep drivability, zspeed has a single disk full faced clutch that is rated to around 500wtq if I recall right, it's the one I use and has been flawless,...
Liked On: 04-28-2022, 10:20 PM
Posted On: 04-28-2022, 09:25 PM
vqholic@Korea liked post by DrBacon On thread : Another vacuum port. A2a Supercharger and Defi Boost Gauge

The way mine is setup is the barb in the front of the manifold goes directly to the bypass valve, as recommended by tial this shouldn't be shared with anything else. I use that port in-between the...
Liked On: 04-17-2022, 05:02 PM
Posted On: 04-17-2022, 03:41 PM
Hotrodz liked post by DrBacon On thread : PPE Long tube headers bad fitment

Just a little update with my experiences with the ppe headers after installation: Fitment is about a 9/10. No issues with steering shaft and sits fine height wise underneath the car. I deduct 1...
Liked On: 04-15-2022, 01:22 PM
Posted On: 04-14-2022, 04:56 PM
Rusty liked post by DrBacon On thread : PPE Long tube headers bad fitment

Just a little update with my experiences with the ppe headers after installation: Fitment is about a 9/10. No issues with steering shaft and sits fine height wise underneath the car. I deduct 1...
Liked On: 04-14-2022, 08:11 PM
Posted On: 04-14-2022, 04:56 PM
ZontheRocks liked post by DrBacon On thread : PPE Long tube headers bad fitment

Just a little update with my experiences with the ppe headers after installation: Fitment is about a 9/10. No issues with steering shaft and sits fine height wise underneath the car. I deduct 1...
Liked On: 04-14-2022, 06:35 PM
Posted On: 04-14-2022, 04:56 PM
redondoaveb liked post by DrBacon On thread : PPE Long tube headers bad fitment

Just a little update with my experiences with the ppe headers after installation: Fitment is about a 9/10. No issues with steering shaft and sits fine height wise underneath the car. I deduct 1...
Liked On: 04-14-2022, 05:00 PM
Posted On: 04-14-2022, 04:56 PM
johnxxx liked post by DrBacon On thread : Shout Out to Those Who Have Installed CJM Billet Fuel Pump Hat

http://host.cj-motorsports.com/pdf/370z%20Fuel%20Pump%20Tech.pdf contains any install info you'd need
Liked On: 04-02-2022, 05:03 PM
Posted On: 04-02-2022, 03:16 PM
Optimiser liked post by DrBacon On thread : Moving Cats downs stream, o2 extension harness

The original topgunz kit? The intercooler in that kit is unfortunately trash, I was seeing IATs at 142+ degrees from a single pull when ambient was around 80. I swapped over to soho's intercooler and...
Liked On: 03-03-2022, 10:32 PM
Posted On: 03-03-2022, 01:52 PM
husam2012 liked post by DrBacon On thread : GT-R turbos on the VQ37

both are open deck blocks and both seem to hold roughly around the same power levels, perhaps with the vr30 being slightly more reliable at those levels. effectively, if you're going for power, the...
Liked On: 03-03-2022, 08:42 PM
Posted On: 03-03-2022, 05:14 PM
NissanTracker liked post by DrBacon On thread : Moving Cats downs stream, o2 extension harness

I believe it's different for the 370z years as well though, I know when I ordered my headers 09-13 was different than 14+
Liked On: 02-21-2022, 09:43 PM
Posted On: 02-21-2022, 09:35 PM
Rusty liked post by DrBacon On thread : ***Topgunz ROTREX C38R Supercharger Kit***

The obnoxious guy on facebook blew his headgasket with the kit, but he probably had it stupidly turned way up.
Liked On: 02-21-2022, 07:19 AM
Posted On: 02-20-2022, 11:45 PM
babyzilla liked post by DrBacon On thread : Lug Nuts for Rays Wheels

Just my two cents but I would never run some random amazon/ebay lugnuts, seems like a really stupid thing to cheap out on.
Liked On: 02-20-2022, 06:30 AM
Posted On: 02-20-2022, 01:27 AM
Spooler liked post by DrBacon On thread : Best sway bars and endlinks for 370z?

This isn't always true but usually Z1's parts are very questionable quality. If it's comparable to something that's known better, get that instead, always.
Liked On: 02-09-2022, 10:42 AM
Posted On: 02-08-2022, 04:14 PM
sx moneypit liked post by DrBacon On thread : Best sway bars and endlinks for 370z?

This isn't always true but usually Z1's parts are very questionable quality. If it's comparable to something that's known better, get that instead, always.
Liked On: 02-09-2022, 06:43 AM
Posted On: 02-08-2022, 04:14 PM
redondoaveb liked post by DrBacon On thread : Best sway bars and endlinks for 370z?

This isn't always true but usually Z1's parts are very questionable quality. If it's comparable to something that's known better, get that instead, always.
Liked On: 02-08-2022, 08:03 PM
Posted On: 02-08-2022, 04:14 PM

Page 3 of 18

Last »

DrBacon

Enthusiast Member

About Me

Statistics

Friends

Likes Received

Mini Statistics

Friends

Recent Visitors

	Spoiler A True Z Fanatic

	Zingston A True Z Fanatic