cv129

Well I am doing my best for Sean and SPL. I am driving the **** out of the arms and they are working as advertised. It did kind of piss me off that after I did a test or two or three I had to ship them off (take them off the Nismo) to the "professional drivers" and then it turns out they didn't test the new versions. As far as I am concerned, I am the best gauge of anyone on these arms. I might not be a race team but I am definitely a hard core track weekend warrior!!!!!!!

So who is CV129? Do I know you?

It is normal to have some power loss when the environment temps are higher. This has to do with high IAT (Intake air temps) when the ECU see's higher temps it pulls timing to prevent ping (...

What did I do today? I bought a Z! So glad to be back!!

Installed Z1 Aluminum Hubcentric 10mm Wheel Spacers on her today. Just enough to fill out the Wheel Wells without pushing the wheels outside the body. Also, 10mm (or 0.4") is just 0.1" less than how...

I’m not trying to be the fastest; or highest HP one out there...but when completed-it shouldn’t be a slouch :iagree:

By the way, I have no idea what the car will make on 30spi of boost. I would guess about 950whp or so. Gotta see in the FI CAC can dissipate the heat. Will be in a new realm of unknown again.

Exactly, I won't know how the car will react. I am on the limits of traction. We shall see where it ends up. Sideways in the triple digits is not something I enjoy. It is going to take some...

Just drive MZ DAIZY like you are driving Mrs. Daisy and that fuel will be gone in no time. No worries.

Burn it off. You are only in trouble if you hear knocking. https://media.giphy.com/media/LFvQBWwKk7Qc0/giphy.gif

As per Rusty, it's not that big of a deal. After a few fillups, you should be good to go. If you notice any knock/ping, let off the accelerator pedal until it goes away.

It's not bad. You're not pushing boost. When you get down to 3/4 tank. Top it off again. Do this about 2 times. Don't run it hard until after the 3th time.

Sitting here debating on what to do with the car tune wise. I have no choice but to go to boost by gear. 4 port MAC valve here we come. I think I want to do 12,12, 17, 24,30,30. 4th is iffy at 25psi...

Tons of info on this subject. I know it's too much to ask for, but maybe try searching for once instead of starting a new thread? The dealer uses CONSULT-III machine to read the trans fluid temp...

That's sweet! Thanks for the redirect. That's what I want to run on my Z as well 🙌

I agree, sometimes plastic is better as a 'sacrificial' part. I think some people who get the metal plates are confused thinking its like some sort of SUV skid plate. In fact a metal one will...

Id listen to spooler and just pick up a low mileage motor from some place and do a swap at your buddies garage. Screw putting that much money into it for a basic dd street car.