|
1st question. Are your heads from this motor any good? If so. You can get a built short block. There have been a couple of them posted on the forum.
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
06-01-2017, 08:16 PM
|
#11 (permalink) |
|
Ronin Samurai - Assassin
 
Join Date: Dec 2011
Location: Fayettenam,Pennsyltucky
Age: 68
Posts: 34,899
Drives: 2011 Nismo GM 6M
Rep Power: 2684436   |
1st question. Are your heads from this motor any good? If so. You can get a built short block. There have been a couple of them posted on the forum. Save a couple of bucks. If not, then long block. Parts for a built motor. Billet crank, rods, pistons, ATI dampener is what I would start with. Decide on what displacement you want to run too if you go this route. Think you could get close to 400hp with cubic inches.
__________________
 浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| O&G's Journal | O&G | Member's 370Z Gallery | 648 | 02-16-2017 03:30 PM |
| My Journal gone | SPOHN | The370Z.com Feedback, Suggestions & Questions | 12 | 11-13-2012 02:12 AM |
| SurfDog's Soundproffing journey | SurfDog | Audio & Video | 9 | 09-24-2012 10:42 AM |
| Holliday's Journal | Holliday | Member's 370Z Gallery | 29 | 12-18-2011 08:26 AM |
| Z BEST Journal | Z BEST | Member's 370Z Gallery | 26 | 01-09-2011 03:19 PM |
661Likes
Threaded Mode
