flashburn's 370Z Journal, Project: FlasHBurN Commences!

cjof2003 · 08-23-2010, 02:11 PM

The drive size is the size sockets that will fit the wrench onto the square part of the wrench. That wrench has a 1/4" square on it, so you will need sockets with a 1/4 square fitting, or an adapter piece.

flashburn · 08-23-2010, 04:02 PM

Quote:

Originally Posted by cjof2003

The drive size is the size sockets that will fit the wrench onto the square part of the wrench. That wrench has a 1/4" square on it, so you will need sockets with a 1/4 square fitting, or an adapter piece.

Ah okay, I had a feeling that was it. I'll check my current sockets, but I'm pretty sure they are 1/4".

Will 20/200ft-lb be a good enough range to do anything I'm going to need to do with my car?

memorylasts · 08-23-2010, 04:57 PM

Quote:

Originally Posted by flashburn

Ah okay, I had a feeling that was it. I'll check my current sockets, but I'm pretty sure they are 1/4".

Will 20/200ft-lb be a good enough range to do anything I'm going to need to do with my car?

The axel bolt(s) will possibly require more, im not sure about anything else. My suggestion is to go with a smaller range and buy maybe 2 instead of one, it will be more accurate that way.

Not sure exactly where you are looking, but maybe like 25-100, and 80-???

Just figure out what you need for the job, because that 20-200 might be to big to get into certain areas. If it is a cost thing buy the one you need now, if it isnt then break it down so they over lap by about 20ft/lbs.

Its been a while since i have really needed one so i apologize if my numbers are off in advance.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
LinPark's 370Z Journal	LinPark	Member's 370Z Gallery	60	07-27-2018 10:07 PM
LunaZ's 370Z Journal	LunaZ	Member's 370Z Gallery	54	11-29-2017 09:33 AM
RCZ's 370Z Journal.	RCZ	Member's 370Z Gallery	1743	08-09-2013 11:55 PM
LateralG'z 370Z Journal	LateralG'z	Member's 370Z Gallery	54	12-25-2010 05:27 PM
My 370Z Journal - The Evo Killer	EVO_Killer	Member's 370Z Gallery	57	09-01-2009 09:51 AM

08-23-2010, 02:11 PM	#1 (permalink)
cjof2003 Base Member Join Date: Sep 2009 Location: Atlanta, GA Posts: 74 Drives: 02 Acura RSX Type S Rep Power: 17	The drive size is the size sockets that will fit the wrench onto the square part of the wrench. That wrench has a 1/4" square on it, so you will need sockets with a 1/4 square fitting, or an adapter piece.