05-02-2019, 01:11 AM
|
#11 (permalink)
|
|
A True Z Fanatic
Join Date: Sep 2012
Location: West Michigan
Posts: 31,410
Drives: Granma red Z
Rep Power: 2684429
|
Quote:
Originally Posted by Rusty
Position carefully. I got mine up a little too high on the fender. I'm about 1 1/2" down from the top roll of the fender. Maybe should have been down about 2 1/2 ". Everything fits flush but the bottom curve of the vent. Have about 1/4"gap that I have to play with. And cut the outside edge of the temp plate. Even doing that. I still had to made the hole bigger to get the vent into the hole.
Do you have the temp plates?
|
yeah, I have the 3d printed templates. I was holding the template up the other day looking for a good position. I was about where you were, 1.5" from the top. Ill look into dropping it a bit.
|
|
|
Similar Threads
15455Likes
Threaded Mode
