08-01-2018, 09:35 PM
|
#11 (permalink)
|
|
A True Z Fanatic
Join Date: Mar 2015
Location: Some Place Cold
Posts: 16,060
Drives: In Circles
Rep Power: 2684397
|
Quote:
Originally Posted by JARblue
Sent my TrackSpec hood vents off to Elmo yesterday 
Evo-R mirrors are boxed up and ready for a FS thread. Anyone want first shot at them? I don't recommend them just because Evo-R but look at it this way - at least with these Jay doesn't get any more money. |
Quote:
Originally Posted by madwi
3 hours better include driving to home depot, making supper, eating and then installing the mirrors.  |
The threads on the inside of the brass nut were stripped and flaked right off. So I used jb weld to fill the hole and tapped a new thread into it. I couldn't find anything even remotely close at Lowes to replace the brass part.
Getting the door panel and bolts off was quick and painless. Maybe 5 minutes per side. I even trimmed the plastic rubber mold piece so it covers the gap below the mirror so no water can enter the door. I did end up just snipping the cables for the electronic controls on the stock mirrors. I'll solder them together later at some point.
__________________
I AM FLOOF! SOMEBODY FLOOF MY HORN!! ALL HAIL THE FLOOF!!I JUST FLOOFED ON THE FLOOR
|
|
|
Similar Threads
11181Likes
Threaded Mode
