Suggestions for Velocity Stacks?

Jordo!

Hey there, folks

I am working on a new project: The goal is to fit a velocity stack to the inside of the OEM airbox.


First, with some careful prying, I was able to separate the airbox into front and rear halves.







Next, I need to fit a velocity stack at the inside intake inlet similar to one of the pictures below...




or




I'm not sure which variant will be easier to fit or work "best" (although I'm leaning towards the one in first pic on the right), and I'll probably have to figure out a gasket of some sort too.

I'll either have to drill in screws to secure or take my chances with JB weld (not sure if that's a good idea after the filter...)

The problem I'm having is in finding velocity stacks I can work with. Ideally it will have a 2.25" ID and an OD that will mate up nicely to the intake inlet on the inside without any gaps (again, I may have to make a gasket of some sort...).

This means it will either need a built in flange or snap into the inlet area without reducing the ID.

I'm having a very hard time finding suitable velocity stacks... internet search points me in directions that have thus far not been exceptionally helpful.

Does anyone have any suggestions on where I could find something that might work?

I'm leaning most toward the flatter flange type fitting, but I'm open to suggestions...

Thanks!

EDITED for correct ID!

__________________
Enjoy it. Destroy it.