|
You may want to visit semtex's DIY Header Install thread: http://www.the370z.com/diy-section-d...tallation.html About halfway down the page the photos semtex posted are identical to the issue I had....it looked to be
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
08-12-2009, 09:38 AM
|
#5 (permalink) |
|
RIP Tony :( (1969-2015)
 
Join Date: Feb 2009
Location: Northern Virginia
Posts: 18,802
Drives: '14 Mustang GT/CS
Rep Power: 69   |
You may want to visit semtex's DIY Header Install thread:
DIY: Stillen header installation About halfway down the page the photos semtex posted are identical to the issue I had....it looked to be off by few inches. There is a solution to the issue in his thread. The solution that Altered Atmosphere did and I agreed on, was to cut about 1 to 2 inches off my Berk HFC's. So far I've not seen or smelled any problems. I was back at Altered last Friday and they put the car on the lift and said they didn't see any leaks or any problems where they had welded things together.
__________________
 SpinTech Mufflers, Airaid CAI, JBA H-Pipe, Lethal Performance Over Axle Pipes, MMD Quarter Panel Louvers, Cervini's Ram Air Type IV Hood, Carbon Fiber Radiator Cover, GT500 Rear Valance, Quad Exhaust Tips
Last edited by 2theextreme; 08-12-2009 at 09:43 AM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stillen Headers installed - Review/Pics/Vid/Dyno | semtex | Intake/Exhaust | 120 | 06-25-2014 12:15 PM |
| Stillen Exhaust, headers, and CAI | midgetcricket | Engine & Drivetrain | 8 | 10-18-2010 08:49 AM |
| Stillen headers group buy (vendors) | SOLISIMO | Intake/Exhaust | 1 | 04-20-2009 09:47 AM |
| Question about Stillen headers... | marcussoori | Intake/Exhaust | 10 | 04-08-2009 02:44 PM |
| Stillen Headers on 370z | Funky370z | Intake/Exhaust | 72 | 04-07-2009 10:38 AM |
Threaded Mode
