|
iam running a stillen lightwheight crank pulley,installed it myself,never dynoed before and after but it did seem to allow engine to rev up thru the bottom end a bit quicker,its
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
03-19-2011, 07:34 AM
|
#1 (permalink) |
|
Enthusiast Member
Join Date: Feb 2011
Location: ontario
Posts: 370
Drives: 09 370z touring
Rep Power: 16  |
iam running a stillen lightwheight crank pulley,installed it myself,never dynoed before and after but it did seem to allow engine to rev up thru the bottom end a bit quicker,its a good value to
|
|
|
|
03-19-2011, 12:06 PM
|
#2 (permalink) | |
|
Base Member
Join Date: Jun 2010
Location: McKinney, TX
Posts: 84
Drives: 2016 370Z Roadster
Rep Power: 17 |
Quote:
I didn't, and am glad I did not attempt it. Took the garage two hours to install my set (not Stillen) and I was watching them the whole time so I know they were working on it. Thing was hard to get off, then had to sand the new crank pulley to get it to fit. Seems nice now but at $190 + $140 installation...well...that's not a big bang for your buck by any means. |
|
|
|
|
|
03-19-2011, 12:10 PM
|
#3 (permalink) | |
|
A True Z Fanatic
 
Join Date: Feb 2010
Location: Dubai
Posts: 1,183
Drives: 09 G37S Coupe 7AT
Rep Power: 22  |
Quote:
Mine did not required any sanding to fit 
|
|
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Motordyne M370 | V8Killer | Intake/Exhaust | 21 | 03-04-2019 08:09 PM |
| What pulleys? | import111 | Engine & Drivetrain | 1 | 10-03-2010 05:14 PM |
| Considering NST Pulleys | Rooskey | Nissan 370Z General Discussions | 4 | 07-23-2010 04:07 AM |
| NST vs Stillen pulleys--which one? | earwicker7 | Intake/Exhaust | 12 | 12-11-2009 10:22 AM |
| Pulleys 101... | MeetJoeAsian | Engine & Drivetrain | 5 | 11-10-2009 08:47 PM |
Hybrid Mode
