370z Nismo Tomei Ground Clearance Issues?

nkryptd1 · 05-31-2015, 10:05 PM

Hey Guys, I recently finished installing the new 370z Tomei ExpremeTi exhaust and noticed there is very little ground clearance for the rear of the exhaust.

I'm currently riding at stock height but was planning to drop it an inch or two... Given the little amount of ground clearance I'm re-thinking that plan. Has anyone else installed the new 370z version and seen ground clearance issues?

I'm hoping I did something stupid like install a pipe upside down but looking for confirmation.

need4speed255 · 05-31-2015, 10:25 PM

Is that a single exit exhaust or just a dual that's not done yet? The outlet pipe looks small if it's just a single.

nkryptd1 · 05-31-2015, 10:38 PM

It's a single... I currently have the silencer in due to one of my neighbor's complaining about the noise =]

Quote:

Originally Posted by need4speed255

Is that a single exit exhaust or just a dual that's not done yet? The outlet pipe looks small if it's just a single.

need4speed255 · 05-31-2015, 10:45 PM

Ah ha. I see now. I bet that single setup sounds much better than the duals.

nkryptd1 · 05-31-2015, 10:52 PM

Not sure if it's better or not but it's loud as heck... My main issue is with the pipe connecting to the muffler, the one that swings out. It has maybe 5" of ground clearance. I've already scrapped the pipe on a flat road w/ stock suspension.

Just seems A LOT lower then past exhausts I've used on other vehicles.

Gilianz · 06-01-2015, 02:19 AM

Well... I am in a load of trouble if the clearance really is that low for stock. I am already lowered. Hopefully this issue isn't that bad. Does the mid-pipe go through the middle of the sway bar then come back around?

FairladyZ10PG · 06-01-2015, 12:04 PM

...looks like if I had tomei's I'd scrape everywhere

guess it's not for me

Hope you won't have too much trouble with the drop op

speedfreek · 06-01-2015, 12:14 PM

I scrape the pipe that tucks under the rear differential. High speeds and bumps don't mix well for the Tomei. Everyone behind me said they liked the titanium sparks at Zdayz

If you are lowered expect that piece to get scratched up. The only good news is that Z1 said you will be able to buy just that piece if it ever gets worn out or damaged to heavily.

Riptide67 · 06-01-2015, 01:24 PM

I'm bagged and ride my car with less than .5 inches of wheel gap front and rear. Dampening set to 18 on all four corners, sitting on a 20 inch wheel. I have no issues. It is pretty on par with the version 1 FI exhaust system with the angle of that pipe.

Gilianz · 06-01-2015, 01:51 PM

Quote:

Originally Posted by Riptide67

I'm bagged and ride my car with less than .5 inches of wheel gap front and rear. Dampening set to 18 on all four corners, sitting on a 20 inch wheel. I have no issues. It is pretty on par with the version 1 FI exhaust system with the angle of that pipe.

Well that is more comforting to know. I'll be getting this version of the Tomei later this week I just don't want to be worried that I'll scrape that piece up too badly.

.c2 · 06-01-2015, 05:39 PM

I don't know about the tomei, but my Invidia sits pretty low where the mid pipe connects. Right by the control arm, I have like an inch or two of clearance on that pipe but don't scrape it often and I'm always flying over bumpy roads.

Gilianz · 06-01-2015, 06:15 PM

Quote:

Originally Posted by .c2

I don't know about the tomei, but my Invidia sits pretty low where the mid pipe connects. Right by the control arm, I have like an inch or two of clearance on that pipe but don't scrape it often and I'm always flying over bumpy roads.

Flying cars are the best cars! But glad to know you don't scrape it often!

nkryptd1 · 06-01-2015, 09:19 PM

Quote:

Originally Posted by Gilianz

Well... I am in a load of trouble if the clearance really is that low for stock. I am already lowered. Hopefully this issue isn't that bad. Does the mid-pipe go through the middle of the sway bar then come back around?

The exhaust routes under the center of the rear sway bar then come back around. Basically comes through the center of the vehicle and then exits left.

nkryptd1 · 06-02-2015, 10:20 PM

Thank you for all the replies guys... Given the comment that the pipe can be replaced w/o purchasing a whole entire exhaust, I feel a little better. I plan to drop it and just go with it. Thanks again guys!

derraj06 · 06-03-2015, 09:19 PM

It also looks like you could rotate that pipe a little and get it higher up. I'm dropped on HKS GT IVs and I scrape but it's because my preload isn't set right and the car is soft right now.

05-31-2015, 10:05 PM	#1 (permalink)
nkryptd1 Base Member Join Date: Sep 2014 Location: CO Posts: 17 Drives: 14 Nissan 370Z Nismo Rep Power: 10	370z Nismo Tomei Ground Clearance Issues? Hey Guys, I recently finished installing the new 370z Tomei ExpremeTi exhaust and noticed there is very little ground clearance for the rear of the exhaust. I'm currently riding at stock height but was planning to drop it an inch or two... Given the little amount of ground clearance I'm re-thinking that plan. Has anyone else installed the new 370z version and seen ground clearance issues? I'm hoping I did something stupid like install a pipe upside down but looking for confirmation. Last edited by nkryptd1; 05-31-2015 at 10:08 PM.

05-31-2015, 10:45 PM	#4 (permalink)
need4speed255 Enthusiast Member Join Date: Oct 2014 Location: Indiana Posts: 262 Drives: 15Nsmo/99 EclipseGST Rep Power: 10	Ah ha. I see now. I bet that single setup sounds much better than the duals. Riptide67 likes this.

06-01-2015, 02:19 AM	#6 (permalink)
Gilianz Enthusiast Member Join Date: Dec 2011 Location: Salina Posts: 379 Drives: 11 370z MB Rep Power: 13	Well... I am in a load of trouble if the clearance really is that low for stock. I am already lowered. Hopefully this issue isn't that bad. Does the mid-pipe go through the middle of the sway bar then come back around? __________________ Takeda CAI : FI Resonated TP : Stillen UD Pulley

06-01-2015, 12:04 PM	#7 (permalink)
FairladyZ10PG A True Z Fanatic Join Date: Aug 2010 Location: SoCal-IE Posts: 1,890 Drives: PGraphite m6 Rep Power: 254	...looks like if I had tomei's I'd scrape everywhere guess it's not for me Hope you won't have too much trouble with the drop op __________________ ///MPPSK///M Performance FRONT SPLITTER///M Performance KIDNEY GRILLS///MPerformance CF MIRRORS///MPerformance CF SPOILER///AC SCHNITZER

06-01-2015, 12:14 PM	#8 (permalink)
speedfreek A True Z Fanatic Join Date: Feb 2012 Location: Huntsville,AL Posts: 1,724 Drives: '12 370Z PW 6sp Rep Power: 18	I scrape the pipe that tucks under the rear differential. High speeds and bumps don't mix well for the Tomei. Everyone behind me said they liked the titanium sparks at Zdayz If you are lowered expect that piece to get scratched up. The only good news is that Z1 said you will be able to buy just that piece if it ever gets worn out or damaged to heavily. Riptide67 likes this. __________________ Tomei\|Berk\|Takeda\|ZSpeed\|Fortune Auto\|Swift\|Eibach\|SPL\|Carbotech\|Motul\|Powertrix\|Stillen\|Aerojacket\|Z1\|Forgestar\|Enkei\|Project Kics\|Nismo Ti\|Llumar speedfreek's journal

05-31-2015, 10:25 PM	#2 (permalink)
need4speed255 Enthusiast Member Join Date: Oct 2014 Location: Indiana Posts: 262 Drives: 15Nsmo/99 EclipseGST Rep Power: 10	Is that a single exit exhaust or just a dual that's not done yet? The outlet pipe looks small if it's just a single.

05-31-2015, 10:52 PM	#5 (permalink)
nkryptd1 Base Member Join Date: Sep 2014 Location: CO Posts: 17 Drives: 14 Nissan 370Z Nismo Rep Power: 10	Not sure if it's better or not but it's loud as heck... My main issue is with the pipe connecting to the muffler, the one that swings out. It has maybe 5" of ground clearance. I've already scrapped the pipe on a flat road w/ stock suspension. Just seems A LOT lower then past exhausts I've used on other vehicles.

06-01-2015, 01:24 PM	#9 (permalink)
Riptide67 A True Z Fanatic Join Date: Jul 2013 Location: Oak Harbor, WA Age: 36 Posts: 1,610 Drives: 09 Nismo #0483 PW Rep Power: 68	I'm bagged and ride my car with less than .5 inches of wheel gap front and rear. Dampening set to 18 on all four corners, sitting on a 20 inch wheel. I have no issues. It is pretty on par with the version 1 FI exhaust system with the angle of that pipe. FairladyZ10PG likes this. __________________ 2009 Nismo 370Z and 1975 Datsun 280Z 2+2 - PNW_INC - Legacy_Ohana Follow me on Instagam @s3zero_z3four

06-01-2015, 05:39 PM	#11 (permalink)
.c2 Enthusiast Member Join Date: May 2012 Location: BC Canada Posts: 414 Drives: 09 370z MB 6MT Rep Power: 12	I don't know about the tomei, but my Invidia sits pretty low where the mid pipe connects. Right by the control arm, I have like an inch or two of clearance on that pipe but don't scrape it often and I'm always flying over bumpy roads. __________________ Instagram // Build Thread Amuse / Mines / Bride / Momo / KW / Hotchkis / Motordyne / Invidia / Injen

06-02-2015, 10:20 PM	#14 (permalink)
nkryptd1 Base Member Join Date: Sep 2014 Location: CO Posts: 17 Drives: 14 Nissan 370Z Nismo Rep Power: 10	Thank you for all the replies guys... Given the comment that the pipe can be replaced w/o purchasing a whole entire exhaust, I feel a little better. I plan to drop it and just go with it. Thanks again guys!

06-03-2015, 09:19 PM	#15 (permalink)
derraj06 Enthusiast Member Join Date: Jun 2013 Location: Huntsville, AL Posts: 406 Drives: MB 370z Rep Power: 11	It also looks like you could rotate that pipe a little and get it higher up. I'm dropped on HKS GT IVs and I scrape but it's because my preload isn't set right and the car is soft right now.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fast Intentions Ground Clearance	Akmcmahon	Intake/Exhaust	7	09-08-2013 11:22 PM
Ground clearance - Nismo w/ FI exhaust	KingJoseph	Nismo 370Z	5	03-08-2013 01:37 AM
Amuse Kit ground clearance	omaragra	Exterior & Interior	15	10-14-2011 01:26 PM
ground clearance ??	Nism0370	Nismo 370Z	3	05-02-2011 02:26 PM
A question about the 370z's ground clearance.	Will3212	Nissan 370Z General Discussions	14	09-25-2009 09:21 AM