Manual ? HKS EVC 6 COLOR BOOST CONTROLLER

lineyho · 02-09-2013, 01:11 PM

I'm planning on getting a tune. The car was tuned last and R&H Garage in Seattle and I do not know anything regarding how they tuned the car. I called them, but their dyno computer crashed since then and lost the information. Currently there is something going on with the car. It does not happen every day but every other day. I'll be just driving along and the car will throw a code and start crackling (knocking) like I'm using bad gas. (Service engine soon light comes on) If I shut the car off for a few minutes and turn it back on, it will run fine again. If I don't shut it off, the car will continue to run in the knocking mode. Not sure if this is the computer changing something. The ARF runs between 14.2-14.6 continually. Running on 92 octane. I had a friend read the codes and there was a misfire code. when the issue begins there is no warning audible or performance wise. It's like a switch turning on. Anyone have an idea ?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
New/improved HKS EVC 6 boost controller	VQStryker	Forced Induction	11	01-03-2014 08:59 PM
Manual Boost Controller Installation Advice?	DIGItonium	Forced Induction	14	02-20-2012 08:14 AM
Manual Boost Controller Recommendations?	DIGItonium	Forced Induction	15	10-02-2011 12:39 PM
Boost controller	LafitteZ	Forced Induction	37	08-07-2011 11:51 PM
[FOR SALE] Hallman Pro Manual Boost Controller	Methodical4u	Parts for sale (Private Classifieds)	1	08-04-2011 03:27 PM

02-09-2013, 01:11 PM	#1 (permalink)
lineyho Base Member Join Date: Dec 2012 Location: Bothell, Wa Posts: 38 Drives: 2010 Base, GTM TT Rep Power: 14	I'm planning on getting a tune. The car was tuned last and R&H Garage in Seattle and I do not know anything regarding how they tuned the car. I called them, but their dyno computer crashed since then and lost the information. Currently there is something going on with the car. It does not happen every day but every other day. I'll be just driving along and the car will throw a code and start crackling (knocking) like I'm using bad gas. (Service engine soon light comes on) If I shut the car off for a few minutes and turn it back on, it will run fine again. If I don't shut it off, the car will continue to run in the knocking mode. Not sure if this is the computer changing something. The ARF runs between 14.2-14.6 continually. Running on 92 octane. I had a friend read the codes and there was a misfire code. when the issue begins there is no warning audible or performance wise. It's like a switch turning on. Anyone have an idea ?