Boosted Performance single turbo build

Boosted Performance

For those that have coolers already, I may have a solution. Push on hose and fittings like this:



I can supply the hose, and fittings. All one would have to do is cut it to size, and and push it on to the fitting. Fittings look like this without the hose:



Still have the -AN ends, so it will work with all oil coolers. I would just have to know what size the -AN inlet is on the cooler. Pretty simple.

Keeping it simple!

chrischhorn

well the '12's use the same filter as the ones without the cooler. The plate is only about 1-1 1/2" thick so it just pushes the filter back a bit. Thats about it though. If thats the case, the relocation kit hose just needs to be 2-3" longer at max to be safe that it reaches and everyone can just trim to fit but good to know!

Cell

What kind of oil temps is the test Z getting with the kit so far?

Boosted Performance

To be honest that is a bit of an overkill. You will find a lot of supra guys for example using a single 3" exhaust to make 600whp, and 3.5" single to get well in to the 800's. Dual 3" on a stock block Z is way more than anybody would ever need IMO. Dual 2.5" exhaust will flow more than a single 3.5" as it has a greater combined surface area than a single 3.5" pipe.



The oil filter relocation kit that I include has to be used with this kit. From there it would only be two oil lines to whatever cooler you have. One line would go from the new oil filter flange "out" port to the oil cooler inlet, and then from the oil cooler outlet back to the new plate where the OEM filter used to sit.

Don't know, the car is not tuned yet, so it can't be driven hard enough to get the oil temperatures too high.

sfearl1

nvm, saw your reply

__________________
Scott