![]() |
They won't crack. The blocks dance around when the cylinder pressure hits a certain point. The casting is not very good. There was not enough interest. The blocks just by
|
|
LinkBack | Thread Tools | Display Modes |
![]() |
#12 (permalink) |
A True Z Fanatic
Join Date: Jun 2014
Location: Ga
Posts: 14,053
Drives: 2013 Nismo 370z
Rep Power: 2684393 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
They won't crack. The blocks dance around when the cylinder pressure hits a certain point. The casting is not very good. There was not enough interest. The blocks just by themselves would cost 10k. Very few folks in the community have that kind of money to add that additional to an engine build. It would be whole lot cheaper than a VR38 swap.
|
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mazworx long blocks | Elmo370z | Forced Induction | 49 | 11-03-2022 09:13 AM |
Billet Engine Block | phunk | Forced Induction | 55 | 10-19-2021 07:54 PM |
Billet VQ37HR block. | Spooler | Forced Induction | 106 | 12-22-2019 10:56 AM |
Billet block VQ | Elmo370z | Engine & Drivetrain | 0 | 06-10-2017 10:19 PM |
VHR Billet Block | Mitco39 | Engine & Drivetrain | 17 | 05-06-2015 01:17 PM |