Stillen SC ?

sportsman2003 · 03-07-2022, 11:37 AM

How reliable is the Stillen SC CARB legal kit?
I am thinking about buying the kit and would not be looking for max power
and pushing the limits of the kit. Is anyone running this set-up on a conservative tune? How has the reliability been if so?

Thanks for the info in advance.

JARblue · 03-07-2022, 12:01 PM

If reliability is what you are looking for, then you should not be looking to boost your NA car

If you're dead set on running boost, the Stillen kit is not your best option.

sportsman2003 · 03-07-2022, 01:26 PM

Quote:

Originally Posted by JARblue

If reliability is what you are looking for, then you should not be looking to boost your NA car

If you're dead set on running boost, the Stillen kit is not your best option.

Thanks, that's what I was looking for. I do enjoy my Z I just wish it had more power. I don't want to sacrifice the reliability for power tho.

My C5 Vette with a KB super charger has been super reliable tho.
I wish there was a good CARB option for the Z.

I will just leave it be and enjoy it for what it is.

Thanks, JAR.

14Q60awdSPORT · 03-07-2022, 01:36 PM

The vq handles boost/ more power pretty well. Auto trans is questionable at higher torque levels. The carb stillen kit is one of the most modest FI kits, considering it is a centrifugal blower it will have the most linear high revving power band with minimal torque. This lower torque will help protect the rods and the trans. Overall It should be one of the more reliable FI options, no FI is as reliable as NA but this would probably be the most reliable FI option.

Averying · 03-07-2022, 02:41 PM

Quote:

Originally Posted by 14Q60awdSPORT

The vq handles boost/ more power pretty well. Auto trans is questionable at higher torque levels. The carb stillen kit is one of the most modest FI kits, considering it is a centrifugal blower it will have the most linear high revving power band with minimal torque. This lower torque will help protect the rods and the trans. Overall It should be one of the more reliable FI options, no FI is as reliable as NA but this would probably be the most reliable FI option.

The reason that the Stillen kit has been labeled as unreliable is not because of the power that it produces, but rather the design itself being flawed. This thread (Before Installing Stillen Supercharger) goes over the issues. Basically MAF before intercooler = bad.

I’m sure the unreliability is hyped up a bit since people are less likely to report good results than to bash it if they have a problem. But Bottom line.. there are better options.

Sent from my iPhone using Tapatalk

wanker · 03-07-2022, 03:32 PM

FWIW, the Stillien SC is your only legal FI option if you live in California. It's hp gains are rather modest for FI, hence the available 36 month/36,000 mileage warranty.

If you want FI reliablity with a full warranty, then get the new Z.

sportsman2003 · 03-07-2022, 04:04 PM

I will pass on the new Z until Nissan does something about the god-awful front bumper/grill.

VHRpurr · 03-07-2022, 04:14 PM

Quote:

Originally Posted by sportsman2003

Thanks, that's what I was looking for. I do enjoy my Z I just wish it had more power. I don't want to sacrifice the reliability for power tho.

My C5 Vette with a KB super charger has been super reliable tho.
I wish there was a good CARB option for the Z.

I will just leave it be and enjoy it for what it is.

Thanks, JAR.

For S/C you're looking at either a Topgun Speedwork s/c kit which utilizes a Rotrex C38R-112 or a SOHO V2 A2A kit which utilizes a Vortech V3-SI blower.

Turbo kits, theres plenty but you didn't ask about it so I'll save it. Honestly, it's all a matter of how much mulah you want to spend.

redondoaveb · 03-07-2022, 04:24 PM

Quote:

Originally Posted by wanker

FWIW, the Stillien SC is your only legal FI option if you live in California. It's hp gains are rather modest for FI, hence the available 36 month/36,000 mileage warranty.

If you want FI reliablity with a full warranty, then get the new Z.

Not true anymore. Eugene Turkov has a CARB legal tt kit that is almost ready to be released

redondoaveb · 03-07-2022, 04:28 PM

Quote:

Originally Posted by Averying

The reason that the Stillen kit has been labeled as unreliable is not because of the power that it produces, but rather the design itself being flawed. This thread (Before Installing Stillen Supercharger) goes over the issues. Basically MAF before intercooler = bad.

I’m sure the unreliability is hyped up a bit since people are less likely to report good results than to bash it if they have a problem. But Bottom line.. there are better options.

Sent from my iPhone using Tapatalk

Plus, the Stillen canned tune is garbage and makes it unreliable. If the OP is in California, which I assume he is if he's asking about CARB,, he would have to go with the Stillen tune because aftermarket tunes have been banned and will show up during testing. That's an automatic fail

VHRpurr · 03-07-2022, 04:39 PM

Quote:

Originally Posted by redondoaveb

Not true anymore. Eugene Turkov has a CARB legal tt kit that is almost ready to be released

Yeah, I'm holding off to see what that one is all about. I'm assuming it utilizes the R35 GT-R turbos. I don't need 700whp, but something in between sure would spice up the drive.

14Q60awdSPORT · 03-07-2022, 05:34 PM

Quote:

Originally Posted by Averying

The reason that the Stillen kit has been labeled as unreliable is not because of the power that it produces, but rather the design itself being flawed. This thread (Before Installing Stillen Supercharger) goes over the issues. Basically MAF before intercooler = bad.

I’m sure the unreliability is hyped up a bit since people are less likely to report good results than to bash it if they have a problem. But Bottom line.. there are better options.

Sent from my iPhone using Tapatalk

Most people trash the kit because it does not make a lot of power and requires a lot of modifications to the kit like A2A conversion to make some real power. And if your goal was power I’d recommend the topgunz rotrex kit (which I have myself)

The MAF location is a concern but on the carb tune it is accounted for in the tune and the boost levels and subsequent heat are much lower so the concern in this case is minimal.

Op is looking for a conservative safe setup to presumably add just a little over FBO NA levels and not push it. The stillen carb seems to fit the bill, at about 370-400whp. Most people want and expect more. It’s easy to get greedy or have unrealistic expectations and then the stillen falls short requiring you to spend a lot to fix it it to make closure to 500whp+ like most people really want to satisfy.

He didn’t mention budget or his DIY capabilities, but IAT relocation isn’t that hard, adding WMI isn’t difficult and would bring IAT down much closer to pre blower temps IAT was reading if he didn’t relocate. but on carb setup I don’t think it’s a huge deal.

redondoaveb · 03-07-2022, 06:50 PM

Quote:

Originally Posted by VHRpurr

Yeah, I'm holding off to see what that one is all about. I'm assuming it utilizes the R35 GT-R turbos. I don't need 700whp, but something in between sure would spice up the drive.

Yeah, it does but you can upgrade the turbos

redondoaveb · 03-07-2022, 06:54 PM

Quote:

Originally Posted by 14Q60awdSPORT

Most people trash the kit because it does not make a lot of power and requires a lot of modifications to the kit like A2A conversion to make some real power. And if your goal was power I’d recommend the topgunz rotrex kit (which I have myself)

The MAF location is a concern but on the carb tune it is accounted for in the tune and the boost levels and subsequent heat are much lower so the concern in this case is minimal.

Op is looking for a conservative safe setup to presumably add just a little over FBO NA levels and not push it. The stillen carb seems to fit the bill, at about 370-400whp. Most people want and expect more. It’s easy to get greedy or have unrealistic expectations and then the stillen falls short requiring you to spend a lot to fix it it to make closure to 500whp+ like most people really want to satisfy.

He didn’t mention budget or his DIY capabilities, but IAT relocation isn’t that hard, adding WMI isn’t difficult and would bring IAT down much closer to pre blower temps IAT was reading if he didn’t relocate. but on carb setup I don’t think it’s a huge deal.

But boost is addicting and that 370-400whp is going to feel slow real quick and he'll want to upgrade. Ask me how I know, or just look at my signature

14Q60awdSPORT · 03-07-2022, 07:01 PM

Quote:

Originally Posted by redondoaveb

But boost is addicting and that 370-400whp is going to feel slow real quick and he'll want to upgrade. Ask me how I know, or just look at my signature

That I agree with. The temptation is hard to overcome especially when its so close.

Nice sig. didn’t notice at first.

I got a topgunz rotrex sc at 11psi by 4500rpm flatlined to redline on E40, cjm return, Id1300, walbro 535, KB boost a pump, isr longtube header etc…. Guessing a solid 500AWHP. 1-2 pulls super hard. 3rd is fun, 4th is already boring lol.

03-07-2022, 11:37 AM	#1 (permalink)
sportsman2003 Base Member Join Date: Dec 2018 Location: In the moment Posts: 191 Drives: Sideways most times Rep Power: 11606	Stillen SC ? How reliable is the Stillen SC CARB legal kit? I am thinking about buying the kit and would not be looking for max power and pushing the limits of the kit. Is anyone running this set-up on a conservative tune? How has the reliability been if so? Thanks for the info in advance.

03-07-2022, 12:01 PM	#2 (permalink)
JARblue A True Z Fanatic Join Date: Mar 2011 Location: Austin, TX Age: 44 Posts: 36,450 Drives: 11 Z34, 98 E36 M3 Rep Power: 2684441	If reliability is what you are looking for, then you should not be looking to boost your NA car If you're dead set on running boost, the Stillen kit is not your best option. Hotrodz, sx moneypit and old guy like this. __________________ 2011 370Z 6MT Sport Gun Metallic \| ARC \| CJM \| Ecutek \| FI \| Fujimura \| R2C \| SPL \| Stillen \| TWM \| Z1 \| ZSpeed \|

03-07-2022, 04:04 PM	#7 (permalink)
sportsman2003 Base Member Join Date: Dec 2018 Location: In the moment Posts: 191 Drives: Sideways most times Rep Power: 11606	I will pass on the new Z until Nissan does something about the god-awful front bumper/grill. wanker likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[FOR SALE] Stillen Dual Exhaust & Stillen front plate holder Pick up in Bay Area	A7594217	Parts for sale (Private Classifieds)	17	08-04-2013 11:27 PM
STILLEN Stillen Gen 3 Ultra Long Tube Dual Intake Kit Nissan 370Z	alright	Forced Induction	4	03-20-2013 02:38 PM
[WTB] wtb nismo seats stillen g3 cai stillen headers and stillen exhaust	bloodvayne	Parts for sale (Private Classifieds)	1	12-18-2011 09:25 PM
FI 12" Exhaust - Stillen G3 Intakes - Stillen UD Pulley - GAINED 28kw or 37HP	bezzita	Australia/New Zealand	29	09-27-2009 12:53 PM
FI 12" Exhaust - Stillen G3 Intakes - Stillen UD Pulley - GAINED 28kw or 37HP	bezzita	Engine & Drivetrain	6	09-06-2009 05:20 PM

03-07-2022, 01:36 PM	#4 (permalink)
14Q60awdSPORT Base Member Join Date: May 2021 Location: washington Posts: 58 Drives: 14 Q60 awd SPORT Rep Power: 3360	The vq handles boost/ more power pretty well. Auto trans is questionable at higher torque levels. The carb stillen kit is one of the most modest FI kits, considering it is a centrifugal blower it will have the most linear high revving power band with minimal torque. This lower torque will help protect the rods and the trans. Overall It should be one of the more reliable FI options, no FI is as reliable as NA but this would probably be the most reliable FI option.

03-07-2022, 03:32 PM	#6 (permalink)
wanker Enthusiast Member Join Date: Apr 2014 Location: San Diego Posts: 443 Drives: 2011 370Z S/T A7 Rep Power: 2902	FWIW, the Stillien SC is your only legal FI option if you live in California. It's hp gains are rather modest for FI, hence the available 36 month/36,000 mileage warranty. If you want FI reliablity with a full warranty, then get the new Z.