Use the same idea on high pressure steam piping joints. A one piece stainless tube circle set in a groove that is on both sides.

The o-rings of years past was made from copper. Known a few that used them.

I have to pay for my engine to be R&R'd and the retune. I can't take the chance that whatever Mazworx does works or may not work. If it does not, I have to pay for the R&R again. This is my last attempt. I am putting the best I can find in it, period. SOHO will be doing the refresh with their TKM top fuel hoops. Just the way it is.

Sounds like the right move going with SOHO top fuel hoops. It sure looks like that's solved the issue

It is not only that, they will stand behind their work 100%.

I have been promised the moon but I keep getting Skittles. WTH....

:iagree:

Feel the rainbow...

https://i.imgur.com/PhsfDhh.jpg

... taste the rainbow!

Now you get my humor. LMAO!!!!

............no one knew you had humor...........everyone thought that you was a stick in the mud...........

FWIW
SCE Gaskets tells me they are working on a vulcan gasket for the vq37

of course, even after its made it's untested.

Good luck with that. I am done testing for other folks. They need to test on their own car and then tell everyone else how it does without hiding the results.

About like the Dynasty head gasket fix. That didn't work either but you won't hear about it. I asked the person who had the issue and he wouldn't own up about it. That is enough to say what happened. Into the black abyss it goes again.

Bank 1 sensor 1 O2 sensor has decided to take a dump on me. Can't complain since it is the original O2 for the car. I have never had to replace them. I get a low voltage code and can see the O2 acting up while logging with Ecutek.

I will be back folks. I don't give up that easy. Enjoy a little shuffle beat while you wait.

The original Live....