Topgunz - air to air upgrade

cupcakez

As I'm fitting the A2A kit onto the Yellow 09 Z...
I ran into a few issues.
Putting in that intake pipe is a total PITA.

Either that or I'm doing it wrong.

It is such a tight fit it isn't funny lol

The coupler from the end of the intake pipe to the intercooler (passenger side) is kind of squished a bit... not enough room to make it flow as it should.

Not sure if this is normal or not.

There is a black bar right behind the coupler that is preventing it from being not so squished. I mean it's on there but it raises some concern for me.

Anyone have any possible remedy to this issue?

__________________
|| ECUTEK (Eugene) || A2A || IPP Built Motor Stage IV Spec || RJM Short Block || Quaife LSD || KW V3 || Stillen-Exhaust || 11.0.1 CR || 928 Full Rebuild || CPZ 34 Row Oil Cooler ||