Driving 40-50 miles


Sent from my iPhone using Tapatalk

Weez are you moving near Orlando? Or should I say "nearer" by any chance. I'll be undergoing the same process pretty soon. Just ordered Prosport Guages today. ( Oil Temp, Oil Press and Wideband Prosport Halo's ) Ordering Southbend Stage 3 with Southbend Billet Flywheel, BDE engine mounts and Mishimoto Radiator this week also. I have to make a choice between the Greddy Profec OLED or the Eboost2 for boost controller but all that will be done in the next day or two. Then next week I cough up the money for the Turbo kit. I just have to buy a new vehicle before I get started with the install.

Moving towards Clearwater but will help out any way I can.


Sent from my iPhone using Tapatalk

I'd appreciate it.

I have two questions about the install.

1. Do we have to remove the power steeing line bracket off of the sub fram. Because i had to do to fit in the turbo.
2. Is there a support bracket for the turbo, because it is only being support by the exhust pipes.

BP V 2.0 turbo kits...ROUND 3 place your order now
 

Can't answer first as I have a different compressor cover.

Second, no the manifold supports the turbo.

BP V 2.0 turbo kits...ROUND 3 place your order now
 

I didn't remove anything, I just crammed it up there
http://uploads.tapatalk-cdn.com/2016...2037391111.jpg
Just have to run the vacuum lines, figure out the intercooler piping from the wheel well to the turbo and the fuel pump

Sent from my iPhone using Tapatalk

I didn't have to remove any bracket other than the one holding the oem cats up. The Turbo fits snugly next to the Trans. Like Jwick said, the snail is held up by the manifold.

Things are coming together nicely guys. Good job all! So very cool to see all these kits/cars come together.

YzGyz

http://[IMG]http://<a href="http://p...1561/image.jpg http://s20.postimg.org/4yxc02kix/image.jpg http://s20.postimg.org/d30ur2hk9/image.jpg[/IMG][/IMG

I just plugged in the add a circuit into the fuze box but trying to figure out where does everything hookup to on the scavenge pump and what's the best way to route it all. This has me and my buddies wondering what to do.

[IMG]http://s20.postimg.org/62hgc1561/image.jpg [url=http://postimg.org/[/IMG]

I just routed it behind the motor and down the drivers side light


Sent from my iPhone using Tapatalk

I did very similar. Mounted the relay on under the cowling by the battery, ran the wire under the cowling and then tucked it away

Your charge pipes going to intake from fmic, did u make your cuts on the inside edges?

Yea I just dremeled the **** out of them


Sent from my iPhone using Tapatalk

With the BP kit, what those intake temps be looking like?


Sent from my iPhone using Tapatalk