Need advise with new shifter knob and boot

kenchan · 05-19-2011, 03:25 PM

Quote:

Originally Posted by TreeSemdyZee

You need a finisher between the knob and the boot. A taller boot really wouldn't do anything because it would probably drop down also.
I know some guys were getting a rubber washer at Lowe's/Home Depot etc. to fill the gap. You also might get a snug rubber wash and put it under the boot on the stalk to hold the boot up.

yah, but on on my G i had the same issue when i did the TWM knob where i intentionally used a taller setting. same result with shaft showing under the knob.

i got a momo boot (taller) and made my ring support inside the boot. it looks factory finish. none of that pull-string look at the top of the boot under the knob.

TreeSemdyZee · 05-19-2011, 05:51 PM

Quote:

Originally Posted by kenchan

yah, but on on my G i had the same issue when i did the TWM knob where i intentionally used a taller setting. same result with shaft showing under the knob.

i got a momo boot (taller) and made my ring support inside the boot. it looks factory finish. none of that pull-string look at the top of the boot under the knob.

Standing on your head.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY: Shifter Boot fix with after market shift knob	Dembflyr	DIY Section (Do-It-Yourself)	11	05-21-2014 09:21 PM
6mt shift knob change, new boot?	spearfish25	Exterior & Interior	19	02-03-2011 09:11 AM
My turn w/ the Short Shifter install, here is the knob I used!	kevr6	Exterior & Interior	29	05-18-2010 06:00 PM
Shifter/ Shift knob vibration	BlackCherryZ	Engine & Drivetrain	4	01-15-2010 08:51 AM
Aftermarket shift knob with short throw shifter and factory boot	m4a1mustang	Exterior & Interior	18	06-09-2009 08:15 AM