08-31-2010, 04:49 PM
|
#10 (permalink)
|
|
A True Z Fanatic
Join Date: Apr 2009
Location: CA
Age: 39
Posts: 9,513
Drives: Scoobaroo
Rep Power: 3407
|
from NAGTROC post:
Quote:
-Disconnect the negative terminal of the battery.
-Remove the front bumper
-Clean off any finger prints or oil from the surface before installation
-Install the DRL in a position where it will not interfere with the bumper fitment
-This system can be wired to the Ignition switch or the light switch (side marker)
-Reconnect the negative terminal of the battery and check that the DRL is functioning properly.
-When reinstalling the bumper, be careful to not scratch the DRL surface.
-The use of painters tape to protect from scratching is recommended during bumper installation.
|
...looks pretty straightforward.
|
|
|
Similar Threads
1Likes
Threaded Mode
