Another Sticky Dash Issue

cv129

Day 2, dash been outside for 24+ hours, another 90+F full sun clear sky. In the picture, right hand side is still dry to the touch, and noticeably more matted. Second picture shows surface temp. The middle line was where I had masking tape on (fell off when dash turned melted under the sun).

I’m leave it out there for more time to see if it’ll fail at some point.

I’m also going to try the same application technique using 303, to see if that will work.

Attached Images

	IMG_3233.jpg (295.7 KB, 22 views)
	IMG_3234.jpg (255.4 KB, 19 views)

__________________
Setrab | RE-71 | SPL | JRZ | Nismo | ARK | Whiteline | RacingBrake | CJM Oil Pan | Ti shield

nis350

First, wanted thank you for posting the results. I hope I read this correctly... So we just have to put a lot of the protectant a few times for it to work?

I can accept a non-sticky semi shiny dash if that's the end result.

cv129

You have to apply it when the dash is hot and shiny. Do it while the dash is in the molten state.

__________________
Setrab | RE-71 | SPL | JRZ | Nismo | ARK | Whiteline | RacingBrake | CJM Oil Pan | Ti shield