CS 15 Nismo Lipkit.....WIP thread

[bm37Oz]

5/16 must huge though? so you just drilled through the carbon fiber underside?

I was thinking of using double sided tape. then use a rivot gun and put 3 rivots from the inside of the bumper so there would not be any holes on the outside of CF lip.

and using 15 lb double side to just basically hold it in place while i drilled holes to to put the rivots through

I was just thinking of using screws instead so it would be easier to remove later if I decide to take it out but worried the screws would come out.

what do you just think?