|
in the fsm it does list them as non reusable although having had them in my hands i can't figure out why the hell not so long as you line
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
05-31-2012, 06:05 AM
|
#3 (permalink) |
|
A True Z Fanatic
Join Date: Aug 2009
Location: In the D
Posts: 3,733
Drives: v8 74 260z ;)
Rep Power: 7252   |
in the fsm it does list them as non reusable although having had them in my hands i can't figure out why the hell not so long as you line them up right when you put them on. there is a little plastic piece in a new one that holds the actuator in place for bolting it to the vvel control shaft. I would imagine that it is for setting the center postion of the actuator on initial startup so that the feedback position sensor can be set to the proper position for each head. There is a procedure outlined in the FSM that your shop should look at to figure out if it can be done with the old actuators.
__________________
ANSWER PRICE LIST Answers - - - - - - - - - - - - - - - - $0.75 Answers (requiring thought) - - - - $1.25 Answers (correct) - - - - - - - - - - $12.50 |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vvel ???? | pokeyl | Tuning | 8 | 06-01-2011 03:33 PM |
| VVEL Tuning | KEVTEX | Tuning | 20 | 10-08-2010 11:23 PM |
| Vvel | destinyZ | Engine & Drivetrain | 13 | 09-19-2010 06:32 PM |
| Booth Babes of 2009 Essen Motor Show, Los Angeles Auto Show, Tokyo Motor Show etc :D | AK370Z | Gentleman's Club | 29 | 12-07-2009 08:33 PM |
| VVEL information? | Orphan | Engine & Drivetrain | 4 | 09-21-2009 12:48 AM |
Threaded Mode
