|
I tried power tools, heat and nothing makes it budge. I will cut the flange off the bolt and try pulling with a set of pullers like you show. I
|
|||||||
16Likes
|
|
LinkBack | Thread Tools | Display Modes |
07-30-2022, 08:53 PM
|
#9 (permalink) |
|
Base Member
Join Date: May 2022
Location: Perth, Australia
Posts: 5
Drives: 2009. Stock-no mods
Rep Power: 5  |
I tried power tools, heat and nothing makes it budge. I will cut the flange off the bolt and try pulling with a set of pullers like you show. I might hit a problem getting the legs of the puller to grip, as there’s no edge to catch. I’ll take some photos.
Luckily I have a new bolt and another pulley from another engine. I’m only doing this to get to the gallery gaskets, so this is only the start of the story. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crankshaft Pulley Install Help | ShadowJester6 | Engine & Drivetrain | 10 | 03-10-2021 10:47 PM |
| Crankshaft bolt removal after NST pulley failed | Rangerz | Engine & Drivetrain | 17 | 07-11-2015 07:49 AM |
| NST Pulley Install - Crankshaft bolt stuck? | Alstann | Engine & Drivetrain | 10 | 12-02-2012 06:28 PM |
| Crankshaft Pulley install question | cotizi | Engine & Drivetrain | 6 | 04-03-2011 09:33 PM |
| Stillen Under Drive Crankshaft Pulley | Musashi | Nissan 370Z General Discussions | 5 | 05-14-2009 06:28 PM |
Threaded Mode
