No Start :(

Zengineer · 03-26-2020, 01:57 PM

Hey All,

I have a 2010 370z. I let it set for about two weeks in my garage. I went to start it today and it won't start

- The engine does turn over with the start button but it wont fire.
- The battery was replaced last year (I'll check the voltage but there's no lag and not even a hint of firing)
-I hear the pumps prime (I got desperate and unhooked the fulel line to verify there is fuel and its being pumped)
-I'm able to access the computer read outs with my OBDII scanner but no codes.
-I've always had issues with the fuel sending unit not reading accurately but it had has almost a full tank.

-It is as if it just wont fire. I changed plugs and coil packs last year.

Any ideas?

Hotrodz · 03-26-2020, 02:57 PM

Key fob battery is dead or steering wheel lock.

Sent from my SM-G965U using Tapatalk

NorthStyle · 03-26-2020, 03:24 PM

Is the starter clicking at all? Have you tried jumping the battery?

Zengineer · 03-26-2020, 03:37 PM

- Yes, car's electrical system fully turns on. The starter turns the car over. It just keeps spinning but not even a spudder. It is as if there is no gas...but there is...cause I checked. I even disconnected the fuel line and turned th ACC on and gas came out.

- Definitely not the starter solenoid problem (dealt with that a few years ago). I would have no electrical with the solenoid issue.

- Im getting ready to place Crankshaft and camshaft sensors to try. I'm at a loss on this one....

husam2012 · 03-26-2020, 04:51 PM

Try unplugging the crank sensor and trying again. You can reach it pretty easily if you remove the passenger side intake.

If the car starts with it unplugged but runs rough, I'm sorry to say but you might have a bad VTC "pulley"

Hotrodz · 03-26-2020, 06:53 PM

It could also be a top hat failure. When mine failed the ground wire came detached as well.

Sent from my SM-G965U using Tapatalk

stansens · 03-30-2020, 06:10 PM

Well as you probably know you need fuel, spark and compression to start. You have fuel so check for spark. Next check for compression. If you have all 3 then there should be some indication of firing although maybe at improper time (i.e. thru the intake or exhaust). Lastly check again for codes or ask a friend to check using a different code reader. Let us know what happens. Good luck.

03-26-2020, 01:57 PM	#1 (permalink)
Zengineer Base Member Join Date: May 2013 Location: Melbourne, Florida Posts: 7 Drives: 10 Nissan 370z BL M6 Rep Power: 11	No Start :( Hey All, I have a 2010 370z. I let it set for about two weeks in my garage. I went to start it today and it won't start - The engine does turn over with the start button but it wont fire. - The battery was replaced last year (I'll check the voltage but there's no lag and not even a hint of firing) -I hear the pumps prime (I got desperate and unhooked the fulel line to verify there is fuel and its being pumped) -I'm able to access the computer read outs with my OBDII scanner but no codes. -I've always had issues with the fuel sending unit not reading accurately but it had has almost a full tank. -It is as if it just wont fire. I changed plugs and coil packs last year. Any ideas?

03-26-2020, 02:57 PM	#2 (permalink)
Hotrodz Premium Member Join Date: Aug 2012 Location: NW, AZ Posts: 9,330 Drives: 10 Nissan 370z Nismo Rep Power: 2684384	Key fob battery is dead or steering wheel lock. Sent from my SM-G965U using Tapatalk __________________ *Fast Intentions TT Installed and Tuned by Seb at SpecialtyZ 610whp 560tq:\|Fast Intentions 3" TT-TDX*\|SpecialtyZ/Fast Intentions 72 Row Oil Cooler\|SZ 6 Puck Clutch & Flywheel\|3GsCustoms\|Z1\|Wavetrac\|Hotchkis\|Whiteline \|Blitz\|Fortune Auto 500\|Fujimura\|SPL\|H&R\|TK\|TWM\|RPM Rollbar\|Sparco\|Next Level Performance\|TrackSpec\|AeroFlow Dynamics\|Pioneer\|

03-26-2020, 04:51 PM	#5 (permalink)
husam2012 Track Member Join Date: Mar 2015 Location: Michigan Posts: 542 Drives: 370Z Nismo Rep Power: 9469	Try unplugging the crank sensor and trying again. You can reach it pretty easily if you remove the passenger side intake. If the car starts with it unplugged but runs rough, I'm sorry to say but you might have a bad VTC "pulley" redondoaveb likes this. __________________ Creator of the GTR TT Conversion Kit, NA Record Holder (401WHP) Ecutek Master Tuner (VQ37, VR30, VR38, B58, S55, S58) BTWTuning

03-26-2020, 06:53 PM	#6 (permalink)
Hotrodz Premium Member Join Date: Aug 2012 Location: NW, AZ Posts: 9,330 Drives: 10 Nissan 370z Nismo Rep Power: 2684384	It could also be a top hat failure. When mine failed the ground wire came detached as well. Sent from my SM-G965U using Tapatalk JARblue, madwi and redondoaveb like this. __________________ *Fast Intentions TT Installed and Tuned by Seb at SpecialtyZ 610whp 560tq:\|Fast Intentions 3" TT-TDX*\|SpecialtyZ/Fast Intentions 72 Row Oil Cooler\|SZ 6 Puck Clutch & Flywheel\|3GsCustoms\|Z1\|Wavetrac\|Hotchkis\|Whiteline \|Blitz\|Fortune Auto 500\|Fujimura\|SPL\|H&R\|TK\|TWM\|RPM Rollbar\|Sparco\|Next Level Performance\|TrackSpec\|AeroFlow Dynamics\|Pioneer\|

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sometimes Push Start doesnt start.	Bad Boy	Engine & Drivetrain	37	08-05-2016 11:46 PM
The car won't start!!..	lkh5650	Nissan 370Z General Discussions	12	03-24-2014 01:39 PM
370z wont start no power . Where to start	acracing118	Exterior & Interior	6	01-05-2013 06:37 PM
Car will start sometimes and not start, need advice	aragona7	Nissan 370Z General Discussions	11	03-08-2012 10:23 PM
cold start/push start	chops	Nissan 370Z General Discussions	21	02-14-2011 03:40 AM

03-26-2020, 03:24 PM	#3 (permalink)
NorthStyle A True Z Fanatic Join Date: Aug 2015 Location: Deutschland + SC/FL USA Posts: 1,235 Drives: 2011 370Z Nismo Rep Power: 24276	Is the starter clicking at all? Have you tried jumping the battery?

03-26-2020, 03:37 PM	#4 (permalink)
Zengineer Base Member Join Date: May 2013 Location: Melbourne, Florida Posts: 7 Drives: 10 Nissan 370z BL M6 Rep Power: 11	- Yes, car's electrical system fully turns on. The starter turns the car over. It just keeps spinning but not even a spudder. It is as if there is no gas...but there is...cause I checked. I even disconnected the fuel line and turned th ACC on and gas came out. - Definitely not the starter solenoid problem (dealt with that a few years ago). I would have no electrical with the solenoid issue. - Im getting ready to place Crankshaft and camshaft sensors to try. I'm at a loss on this one....

03-30-2020, 06:10 PM	#7 (permalink)
stansens Base Member Join Date: Nov 2015 Location: toronto, canada Posts: 144 Drives: 2016, 370z Rep Power: 192	Well as you probably know you need fuel, spark and compression to start. You have fuel so check for spark. Next check for compression. If you have all 3 then there should be some indication of firing although maybe at improper time (i.e. thru the intake or exhaust). Lastly check again for codes or ask a friend to check using a different code reader. Let us know what happens. Good luck.