|
I dont use the original manual, but I used over 15 liters of gnissan tranny fluid to flush the hole system. I filled the tranny up, start the engine, until
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
09-10-2019, 01:00 PM
|
#3 (permalink) |
|
Base Member
Join Date: Feb 2013
Location: Germany
Posts: 16
Drives: 10 Nissan 370Z w Aut
Rep Power: 20924   |
I dont use the original manual, but I used over 15 liters of gnissan tranny fluid to flush the hole system. I filled the tranny up, start the engine, until it has about 35 degrees Celcius. I think this is 95 degrees fahrenheit, change every gear P, R, N, D for 10 seconds and then I oben the screw until the fluid drops in short frequencies.
What do you mean. Was it correct? |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Limp mode after engine swap | Alaadinz | Engine & Drivetrain | 4 | 06-13-2019 11:24 PM |
| 370Z Nismo, engine stops and won’t start | Morfiy | Nissan 370Z Warranty / Scheduled Maintenance / Servicing / Repairs | 3 | 05-01-2019 11:45 AM |
| Limp Mode after Steam engine clean | wtolbert | Engine & Drivetrain | 4 | 07-20-2016 12:47 AM |
| Service Engine Soon + Limp Mode | Terrace | Nissan 370Z General Discussions | 15 | 02-06-2014 05:11 PM |
| Engine revving unnecessarily high/ S-mode malfunction | MileHighZ | Nissan 370Z Warranty / Scheduled Maintenance / Servicing / Repairs | 7 | 06-04-2011 11:03 PM |
7Likes
Threaded Mode
