|
My Stillen G3 with Jet Hot inside and outside coating, runs 8 degrees over ambient when the car is in motion. Heat soak when stopped is a serious issue. When
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
08-08-2018, 10:26 AM
|
#10 (permalink) |
|
Track Member
Join Date: Oct 2016
Location: OKC
Posts: 822
Drives: 2010 touring
Rep Power: 7842   |
My Stillen G3 with Jet Hot inside and outside coating, runs 8 degrees over ambient when the car is in motion.
Heat soak when stopped is a serious issue. When I am at the dragstrip between runs in the pits, I point the car into the wind and open the hood. Then I just wait until AIT is close to ambient before running it again. On the last dyno session, the ambient was 86F and the AIT was 111F. This was with no fan in front of the car after three runs. I think that there was a big power penalty since the AIT was so high. Last edited by SG4247; 08-08-2018 at 12:58 PM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Takeda/Afe CAI Intake Air Temperature Situation | koriental | Intake/Exhaust | 1 | 08-22-2016 02:14 PM |
| Temperature and HP | Troyz | Nissan 370Z General Discussions | 21 | 09-23-2013 05:09 PM |
| Why is intake manifold pressure and exhaust temperature important? | Arrvaxx | Engine & Drivetrain | 9 | 09-07-2013 02:18 PM |
| Intake Air Temperature affect on Ignition Timing | SouthArk370Z | Engine & Drivetrain | 14 | 09-10-2012 01:15 PM |
| Oil temperature | lachap55 | Engine & Drivetrain | 31 | 09-10-2012 06:09 AM |
1Likes
Threaded Mode
