Clutch & Flywheel advice please

B&W_Evader

That sounds like the Competition stage 2 I put in my truck. Definitely want lower level of low RPM chatter.

__________________
|RIP|6spd-sport|OSG-LSD|XP8|RBF600|Eibach Sways|RE-71R|FI-34Row|Gen3-CAI|Yaw P.S.|

Joe@ZSpeed

Low RPM/High load under 2300rpm rattle will always be there unless you run the stock dual mass flywheel.

Any kit will rattle some down low with a single mass flywheel.

You can get the "Quiet Disk Option" with the South Bend or ZSpeed kits which is a huge improvement over any other clutch on the market @ killing the very annoying idle rattle but it will not get rid of the low rpm/start out rattle.

__________________
http://photos.zspeedperformance.com/...ardsize=468x60
Phone 937-506-7224
E-Mail Sales@Zspeed.com
www.ZSPEED.com

socce

Joe, I bought a second hand z1 clutch and light flywheel kit that is in good shape. Is the 'Quiet Disk' an option that I could use to replace the old plate in the z1 kit ?

Joe@ZSpeed

I'm not sure what they use as far as disk thickness so I cannot tell you 100%
Most of our kits are engineered to work with a performance marcel cushioned disk so they engage smoothly but still retain an accurate bite point.
Some pressure plates will not release this type of clutch completely unless they are designed to work with it.

__________________
http://photos.zspeedperformance.com/...ardsize=468x60
Phone 937-506-7224
E-Mail Sales@Zspeed.com
www.ZSPEED.com