|
1. Pop "up" the knobs to ease desoldering and removal of the complete rotary switch. Press in and lift, and then move to another side to make it easy to
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
08-29-2009, 10:54 PM
|
#2 (permalink) |
|
A True Z Fanatic
Join Date: Jan 2009
Location: Kansas
Posts: 3,800
Drives: 09 Z34-TT 6MT
Rep Power: 43   |
A/C Control Panel
1. Pop "up" the knobs to ease desoldering and removal of the complete rotary switch. Press in and lift, and then move to another side to make it easy to lift the knob.
 2. Underneath the PCB, observe the large solder pads. Each rotary switch has two posts that need to be desoldered. Also, each rotary switch has 5 small terminals that need to be desoldered as well. Be very careful with these terminals as excess heat can delaminate and loosen the solder pad. Then the switch can be slowly pulled away from the PCB and out of the housing.  3. Below is a picture of the bottom of the rotary switch with the posts and terminals.  4. Below is a picture of the LEDs revealed when removing the rotary switches and releasing the PCB from the housing. The large PLCC LEDs are the indicators, while the small 0805 LEDs are for backlighting.  5. Here is the completed modification. Notice the S-MODE switch was modified as well. 
__________________
Last edited by DIGItonium; 02-08-2011 at 07:44 PM. Reason: Embed Picture Files |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Want to change the interior | Gables | Exterior & Interior | 10 | 05-17-2012 04:19 PM |
| pod lighting color change? | g35300mm | Nissan 370Z General Discussions | 2 | 02-10-2010 01:28 PM |
| what interior color?? | Arcangel | Nissan 370Z General Discussions | 15 | 03-08-2009 10:11 PM |
| powdercoating just to change color? | mattkim85 | Nissan 370Z General Discussions | 2 | 03-02-2009 03:08 PM |
30Likes
Threaded Mode
