DIY: Headlight LED's and blackout

DIGItonium

I'd prefer epoxy over hot glue because it tends to get soft especially in this 100 deg. weather and direct sunlight. Sweet job! I don't have the time and guts to pull apart my headlight assembly.

__________________

AK370Z

GReat job! I don't think I have the guts to drill into my headlights. for job well done.

__________________
The370Z Signature Pictures ll Want to rock our forum decals on your car? Then click here! ll How to Embed YouTube Videos In a Post
STOP! (Hammertime) ll Become a Premium Member Click HERE ll F.A.Q.
Are You a Nissan Dealer? Click Here to Become A "Supporting Dealer" and Start Listing Your 370Zs In Our Inventory Section
My Monterey Blue Z ll My Exhaust --> My Intake --> G3
Nissan's Official Response Regarding Oil Temp Issue: CLICK HERE
Need a Set of Cheap Winter wheels /Tires? Then Visit The Banner Link Below and Place Your Order. You'll Help Keep The370Z Alive.

Caravanshaka

Epoxy isn't a bad idea to use for mounting. A little more permanent might not be a bad thing

All of the LED's (except that 3rd one from the bottom) fit in there pretty snug without the glue, so I don't foresee any problems with it. Epoxy is a good alternative if you are a little uncomfortable with hot glue.

Time wasn't too bad, I could do a second set in about 6-7 hours...but it definitely takes guts, and it was still nerve racking!