DIY: GT-SPEC 4-Point Ladder Bar

dcrew1x · 10-31-2009, 09:17 PM

DDM already made a DIY for this but very nice writeup Equinox

+1

The DIY is very descriptive and pretty much leaves no question on how to get that sucker on

I'm still not sure if I want to get this and end up being overkill. I've purchased the Nismo brace kit which stiffens the chassis in the front, rear, and mid (interior).

I wish the Nismo (yamaha) performance dampers were available for purchase.

On another note, you planning on purchasing the GT-spec lower tie bar?

Equinox · 11-01-2009, 09:06 AM

Quote:

Originally Posted by dcrew1x

DDM already made a DIY for this but very nice writeup Equinox

+1

The DIY is very descriptive and pretty much leaves no question on how to get that sucker on

I'm still not sure if I want to get this and end up being overkill. I've purchased the Nismo brace kit which stiffens the chassis in the front, rear, and mid (interior).

I wish the Nismo (yamaha) performance dampers were available for purchase.

On another note, you planning on purchasing the GT-spec lower tie bar?

Already got the lower tie bar, it's in my picture album, and I posted a thread about it, I just didn't make a how to.

dcrew1x · 11-01-2009, 10:39 AM

Sweet. Just took a look at it. Good stuff

I plan on ordering the lower tie brace for now and later on down the road the 4pt brace.

10-31-2009, 09:17 PM	#1 (permalink)
dcrew1x Track Member Join Date: Jun 2009 Location: SoCal Posts: 821 Drives: Graphite Bullet Rep Power: 370	DDM already made a DIY for this but very nice writeup Equinox +1 The DIY is very descriptive and pretty much leaves no question on how to get that sucker on I'm still not sure if I want to get this and end up being overkill. I've purchased the Nismo brace kit which stiffens the chassis in the front, rear, and mid (interior). I wish the Nismo (yamaha) performance dampers were available for purchase. On another note, you planning on purchasing the GT-spec lower tie bar? __________________ 2009 PG 6MT Sports Stillen Gen3 CAI \| Stillen CBE \| AMS Short Shifter \| Nismo Brace Kit

11-01-2009, 10:39 AM	#3 (permalink)
dcrew1x Track Member Join Date: Jun 2009 Location: SoCal Posts: 821 Drives: Graphite Bullet Rep Power: 370	Sweet. Just took a look at it. Good stuff I plan on ordering the lower tie brace for now and later on down the road the 4pt brace. __________________ 2009 PG 6MT Sports Stillen Gen3 CAI \| Stillen CBE \| AMS Short Shifter \| Nismo Brace Kit

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
bent my jacking point underneat	thispecialk	Exterior & Interior	31	06-30-2012 09:15 AM
Summit Point Sept 11 (FATT)	ErnieT	Mid-Atlantic Region	20	08-17-2009 04:14 PM
DIY: GTSPEC 4-Point Ladder Brace	M.Bonanni	DIY Section (Do-It-Yourself)	8	07-29-2009 01:44 PM
370Z Final Point of Assembly	daytontp	Nissan 370Z General Discussions	9	05-11-2009 05:49 PM