SPL Parts Discussion

ZX_man · 08-18-2020, 09:54 PM

Quote:

Originally Posted by Rusty

i have just about the whole SPL catalog on my Z. No issues so far.

Yeah I was skimming your suspension build threads earlier. IIRC you installed yours before the aluminum ones came out. Unless you've upgraded since?

Quote:

Originally Posted by bpchaos

Also, shouldn't these pieces only be loaded in tension and compression? Should be plenty strong for that since they're made from a billet of aluminum.

Yeah they're only in tension and compression, but there's still pretty high bearing stresses on the upright flanges given their small cross-section.
Also the camber arm is one of the lower members on the upright. This means it experiences high cornering loads since it is closer to the contact patch.

redondoaveb · 08-18-2020, 09:57 PM

Quote:

Originally Posted by ZX_man

Yeah I was skimming your suspension build threads earlier. IIRC you installed yours before the aluminum ones came out. Unless you've upgraded since?

Yeah they're only in tension and compression, but there's still pretty high bearing stresses on the upright flanges given their small cross-section.
Also the camber arm is one of the lower members on the upright. This means it experiences high cornering loads since it is closer to the contact patch.

If you want, buy a set of the billet one's and I'll trade you my steel one's for the billet one's

Rusty · 08-18-2020, 11:23 PM

Quote:

Originally Posted by ZX_man

Yeah I was skimming your suspension build threads earlier. IIRC you installed yours before the aluminum ones came out. Unless you've upgraded since?

Yeah they're only in tension and compression, but there's still pretty high bearing stresses on the upright flanges given their small cross-section.
Also the camber arm is one of the lower members on the upright. This means it experiences high cornering loads since it is closer to the contact patch.

I haven't up-graded.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Car Sex (discussion)	Dragster	Gentleman's Club	149	11-27-2018 10:59 PM
Rotor Discussion	Minsu	Brakes & Suspension	33	10-13-2014 09:05 PM
VK Swap Discussion...	bullitt5897	Engine & Drivetrain	51	05-19-2013 10:09 PM
5D3 Discussion	FrancoPhoto	Photography	6	07-09-2012 12:08 AM